HOOKE ROAD BXG.3006 User manual

Side Steps
(1) Contents:
(2) Tools required:
a. 13mm Socket Wrench;
b. 10mm Wrench;
BXG.3006
BXG.3007
a.1x Driver Side Step；
b.1x Passenger Side
Step;
c.Attached bolts;

(3) Installation time:
About 1 hour, 2-3 people may be needed. Installation time may differ
according to your mechanical skill level.
(PLEASE VERIFY ALL PARTS ARE PRESENT AND READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION!)
To view the electronic version (BXG.3006 & BXG.3007), please scan
the QR code.

(4) Installation instruction:
Step 1:
Begin by removing the factory side step.Then ready to install the new
side step.
Step 2:
Install the corresponding side step for the passenger side. The front
end is longer than rear end as the picture shown.
Insert the side step into the car frame.
Long
Short

Step 3:
Then tighten the bolts on the three parts. You may have to lie under
the chassis to screw the bolts.

Note:
Bolts are your Original Bolts.But if you don’t have it.Then use the attached bolts.
Tighten all the bolts.
Step 6:
Repeat the operation for driver side.
Step 7:
Once you have everything in place you are finished with the
installation.Congratulations on the purchase and installation of a quality
Hooke Road product!

Attention:
1.The product parts in this instruction may differ slightly from
the actual product contents but generally does not affect the
installation of the product.
2.Please feel free to contact your distributor if you have any
kind of question about your purchase.
Hooke Road to find your parts