Hooker Furniture 5107-75310 User manual

1/2
ASSEMBLY INSTRUCTION
Item#: 5107-75310 Ladderback Side Chair-2 per carton
** Please make sure you have all parts indicated below prior to assembly.
Diagram 1 Diagram 2
Assembly Steps:
There are two K/D chairs in one box. Please follow numbers on one chair and letters on another chair during
assembly.
1. Place back frame(E) on a clean surface.
2. Attach back rail of the seat frame (F) to back frame (E) by aligning the holes in center of seat frame and
back frame, then secure with bolt (C) ,lock washer(B) ,flat washer(A).
3. Tighten rear corner blocks of seat frame (F) to back legs of frame (E) using bolts (C), lock washers(B) ,flat
washers(C). (See diagram 1)
4. Assemble front corner blocks of seat frame (F) with front legs using bolts (C), lock washers (B), flat
washers (A). Hand tighten these bolts. (See diagram 2)
5. After all bolts are attaching and hand tightened, turn the chair upright.
6. Level the chair following the “chair leveling instruction” as below.

2/2
7. Make sure the chair is level and then tighten all bolts completely by using the allen wrench(D).
PLEASE READ THESE INSTRUCTIONS PRIOR TO ASSEMBLING THE
CHAIRS
CHAIR LEVELING INSTRUCTION SUPPLEMENT
Chair leveling procedures:
To make the assembly process easy and efficient, please read the entire instruction sheet prior
to assembling of the chair. Make sure all hardware listed is included. To properly assemble the chair,
none of the bolts should be fully tightened until all components are attached to the chair. This will allow an
opportunity to level the chair and prevent any unnecessary “rocking”.
1. Place the loosely assembled chair on a hard flat surface.
2. Apply gentle downward pressure on the seat. This step eliminates rocking and
ensures the chair will be level.
3. Once the chair is level, tighten all bolts and nuts.
Note:
Most floors have slight irregularities that can affect chair leveling. If your chair is
uneven when placed in its desired location, perform the following steps:
1. Loosen front legs to finger tight.
2. Extend both front legs upward to their fullest length.
3. Gently push downward on the front edge of the seat until all four legs rest on the floor.
4. Re-tighten all bolts and nuts.
Cleaning Instruction: Clean finished parts with a damp cloth using a mild dishwashing liquid and water solution.
Polish the finish with soft cloth and an industry recognized furniture polish.