Hooker Furniture 5750-75400-LTWD User manual

1/2
ASSEMBLY INSTRUCTION
Item#: 5750-75400-LTWD Upholstered Arm Chair
** Please make sure you have all parts indicated below prior to assembly.
Assembly Steps:
1. Place chair back on a clean surface.
2. Attached seat frame (L) to chair back (J) by using bolt (A), lock washer (B) , flat washer (C) at the
center location and tighten by Allen Wrench(D). Then, tighten seat frame (L) to chair back (J) by
using bolts (E), lock washers (B), flat washers (C) and secured by using allen wrench (D) at corner.
(See diagram 1)
3. Attached front legs (I) to seat frame (L) by using bolts (E), lock washers (B) ,flat washers (C) and
tighten by allen wrench (D).(See diagram 1)
4. After all bolts are attached and hand tightened, turn the chair upright.
5. Attached front leg (I) to chair back(M)by using bolts (H), lock washers (B) and flat washers (G).
Tighten all bolts by allen wrench (D). Insert wood plugs (F) into bolts (H).
6. Make sure the chair is level and then tighten all bolts completely by using allen wrench (D).
Diagram 1
Diagram 2

2/2
PLEASE READ THESE INSTRUCTIONS PRIOR TO ASSEMBLING THE
CHAIRS
CHAIR LEVELING INSTRUCTION SUPPLEMENT
Chair leveling procedures:
To make the assembly process easy and efficient, please read the entire instruction sheet prior to
assembling of the chair. Make sure all hardware listed is included. To properly assemble the chair, none of
the bolts should be fully tightened until all components are attached to the chair. This will allow an
opportunity to level the chair and prevent any unnecessary “rocking”.
1. Place the loosely assembled chair on a hard flat surface.
2. Apply gentle downward pressure on the seat. This step eliminates rocking and ensures the chair to
be level.
3. Once the chair is level, tighten all bolts and nuts.
Note:
Most floors have slight irregularities that can affect chair leveling. If your chair is uneven when placed
in its desired location, perform the following steps:
1. Loosen front legs to finger tight.
2. Extend both front legs upward to their fullest length.
3. Gently push downward on the front edge of the seat until all four legs rest on the floor.
4. Re-tighten all bolts and nuts.
Cleaning Instruction: Clean finished parts with a damp cloth using a mild dishwashing liquid and water solution.
Polish the finish with soft cloth and an industry recognized furniture polish.