Hooker Furniture 5603-90867-LTBR User manual

1/3
ASSEMBLY INSTRUCTION
ITEM# 5603-90867-LTBR 6/6 Upholstered Panel Headboard
5603-90868-LTBR6/6 Upholstered Panel Footboard
5603-90853-LTBR6/6 Upholstered Rails
Caution: Please make sure you have all parts indicated below prior to assembly.
This bed is heavy and can best be assembled with the help of two or more persons.

2/3
Please note the hardware bag to assemble side rails to HB&FB is in the box of side rails.
Assembly steps:
1. Insert 2 bolts (H) into holes of each side post on Headboard (A) and Footboard (B), attach the end
of side rails (C) to bolts (H) on posts by using 2 curved washers (G) and 2 nuts (E), tighten nuts (E)
securely with spanner wrench (F). (See diagram 1)
Diagram 1
2. Take out center supports (L) from the rail box, attach center supports (L) to slats by using 2 bolts
(Q), 2 lock washers (V) and 2 flat washers (U). Secure bolts (Q) by using allen wrench (R). (See
diagram 2)
See Diagram 1
See Diagram 2
See Diagram 3
See Diagram 5

3/3
Diagram 2
3 Attach slats (D) to side rails (C), align pre-drilled holes on the slat to holes on the cleat of side rail
(C), using screws (K) to tighten both. (See diagram 3)
Diagram 3
Note: You can change the height of slat by adjusting the height of cleat on side rail as shown in
diagram 4. Remove bolt (I), lock washer (O) and flat washer (J) from the cleat by turning the
bolt (I) with allen wrench (M) in anti-clockwise direction. Adjust the cleat to a desired position,
and then secure lock washer, flat washer, bolt in a clockwise direction by turning with allen
wrench.
Diagram 4

4/3
You can adjust the height of center supports (L) as shown in Diagram 5 to meet your need by the
following steps.
1. Keep center supports(L) as 3pcs of woods if need to adjust the height to align top holes on side
rails.
2. Unscrew bolts on center supports (L) with allen wrench (R) and take out middle wood(L2), then
adjust the height of center supports, align holes on other 2pcs of woods(L1&L3) and tighten
them together with 2 bolts(Q), 2 lock washers (V) and 2 flat washers（U）by turning with allen
wrench(R) in a clockwise direction.
Diagram 5
Cleaning Instruction: Clean finished parts with a mild dishwashing liquid and water solution on a damp
cloth. Polish the finish with soft cloth and an industry recognized furniture polish.