Kit Contents
1 x Oscillating Sprinkler
1 x Accessory Connector
The Oscillating Sprinkler has a number of adjustment
controls ideal for all of your watering needs. It has a
rectangular spray coverage that can be adjusted to
cover an area up to 15m x 12m. This flexibility allows you
to effortlessly water a large or narrow lawn, against an
edge, or only one side of your lawn.
Assembly Instructions
STEP 1 Connect to Sprinkler
Screw the Hoselink Accessory Connector into the sprinkler.
STEP 2 Connect to Water Supply
Connect to a water supply by attaching your Hoselink-
fitted hose end to the Accessory Connector included with
the sprinkler.
STEP 3 Turn on Water
Turn on water source.
Cleaning Tips
By following a few simple cleaning tips, your sprinkler
should provide years of reliable service.
–Clean the water inlet filter by unscrewing your Accessory
Connector to reveal the filter. Remove, rinse and re-fit.
–Use the provided cleaning pin to clear any clogged
spray nozzles. Then, run water throughout with the
cleaning pin removed to flush the system.
Maintenance Tips
– If sprinkler does not operate properly, remove the
cleaning pin from the end and flush water through.
– Drain the sprinkler after use.
– Do not allow water to freeze in the sprinkler.
– Store out of direct sunlight.
– If the sprinkler stops oscillating as expected, spraying
some silicone lubricant onto the tabs and underneath the
sprinkler should help keep everything moving.
Components
Sprinkler Range
Under good water pressure the Oscillating Sprinkler
can cover up to a 12m x 15m rectangle. The range and
width can be adjusted by utilising the on/off valves and
adjusting the tabs.
Replacement Parts Available
Cleaning Pin, Black Watering Jets, On/O Buttons & Flow
Control Dial
