Kit Contents
1 x Impulse Sprinkler
1 x Accessory Connector
1 x Metal Ground Spike
Delivering a solid, even coverage over a large distance
and sufficiently soaking the full area, this sprinkler can be
adjusted to cover a radius of 30° to 360°. Depending on
the strength of your water pressure, its coverage can also
reach up to 30m in diameter.
Assembly Instructions
The Impulse Sprinkler comes pre-assembled. By using the
foot press that extends out from the body of the sprinkler,
simply push the spike into the ground and connect to your
Hoselink-fitted hose.
WARNING: Do not use excessive force.
Dig hard soils first before pushing into ground.
Using the Sprinkler Head
1 Adjust the radius from 30° to 360°
Turn the two silver rings (reference A on image) at the
base of the sprinkler head to set the watering parameter.
2 Water in a 360° radius
Lift the silver stopper (reference B on image) to allow free
rotation of the sprinkler head in a 360-degree rotation.
3 Adjust the range and arc of the water
Lift or depress the silver tab (reference C on image) in
front of the water outlet.
4 Change the spread of water
Screw the pin to the side of the silver tab to interrupt the
water flow and spread it closer to the sprinkler.
NOTE If you do not have a Hoselink hose, you’ll need
to convert to Hoselink’s fittings, or remove the Accessory
Connector and use another click-on male connector.
NOTE You can use multiple Impulse Sprinklers using a daisy
chain of hoses, however you will require extremely high-
water pressure for this to work efficiently. Remove the stop
cap and use a tap to hose connector set (item 2310) and a
hose end connector (item 2420) to attach another length of
hose that runs to a second sprinkler. We would recommend
a maximum of two sprinklers running off one hose to avoid.a
t
er press
ure issues from occurring.
Troubleshooting
If the sprinkler head has stopped turning, check for
blockages by removing the Hoselink accessory connector
and sprinkler head, then rinse both with warm water. Running
warm water through the system with the head removed will
remove any debris caught inside. Afterwards, spray the tool
with silicone lubricant to prevent future blockages.
Replacement Parts Available
Sprinkler Head & Stop cap
item 2420
item 2310
