Hoselink 1003-WG User manual
Auto-fill Pet Water Bowl
For more information visit
hoselink.com.au
or call
1300 900 617
youtube.com/hoselink
MODEL: 1003-WG
Auto-fill Pet Water Bowl
MODEL: 1003-WG
Cultivating ConnectionsCultivating Connections
User ManualUser ManualUser Manual
Kit Contents
1 x Pet Bowl
1 x Float Valve
1 x Cover
1 x Hoselink Accessory Connector
Assembly
1Open box and remove parts from inside bowl. Give
the bowl a clean with soap and water.
2Screw the Hoselink Accessory Connector into the
float valve.
Connecting Water Supply
Note: To connect your hose with Hoselink fittings please
refer to the website for fitting instructions.
1Fill the pet bowl with water directly from the hose to
about 2cm from the rim. This will save time.
2Once filled, attach the Hoselink hose to the pet bowl
and place the bowl on a flat horizontal surface.
3Turn the tap on to start filling.
Note: The bowl only requires very low water pressure to
operate. Only turn tap on lightly.
Use with P.E.T. Drink Bottle
1Fill pet bowl to 2cm from the rim.
2 Fill P.E.T. bottle with water. The bottle upside down
and screw into the PET hole. For this step make sure
you are in an area that can get wet.
3 The P.E.T. bottle will empty until it reaches the fill
line. The water will then dispense out of the P.E.T. bottle
whenever your pet drinks from the bowl.
