HOUSBAY RS10 User manual
RS10 User Manual
If a faulty product is found when setting up
Sound Machine with Alarm Clock
1 Year Warranty
FCC Requirement
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment. This device complies with Part 15 of
the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy, and if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
– Consult the dealer or an experienced radio/TV technician for help.
15.21 Information to user
The users manual or instruction manual for an intentional or unintentional radiator shall caution
the user that changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to poerate the equipment.In cases where the
manual is provided only in a form other than paper,such as on a computer disk or over the
internet,the information required by this section may be included in the manual in that alternative
form,provided the user can reasonably be expected to have the capability to access inofrmation
in that form.
[54 FR 17714,Apr.25,1989,as amended at 68 FR 68545,Dec.9,2003]
only.Please keep plugged in!
TIPS:
1. Battery backup is for saving TIME/ALARM settings
Please read all the instructions carefully and keep this in a safe
place for future reference.
1
INSTRUCTIONAL VIDEO:
Please scan the QR code here to access the instructional
video of this product.
2
• 1* Sound Machine with Alarm Clock
• 1* 1.5m DC Adapter
• 1* User Manual
• 1* CR2032 Battery
PACKAGE INCLUDE:
AC, 100-240V, 50/60Hz.
POWER SPECIFICATIONS:
• 18 Soothing Sounds
• 30 Levels Adjustable Volume
• 7 Colorful Night Light
• 0-100% Brightness Control For Display
• 5 Alarm Sounds & 9 Minutes Snooze
• Sleep Timer
• Battery Backup(Only Memory Function)
• 12/24H Mode
FEATURES:
FRONT VIEW
3
TOP VIEW
ALARM SETTING
AND ON/OFF
VOLUME -
FORWARD
SLEEP TIMER
TIME SETTING
VOLUME +
BACKWARD
SOUND MACHINE
ON/OFF
SNOOZE/ NIGHTLIGHT
ALARM
AM
Time
BACK VIEW
BOTTOM VIEW
4
DIMMER CONTROL (0-100%)
POWER CONNECTOR
BATTERY COMPARTMENT
(Battery is built in already)
5
1. Plug the adapter into a standard household outlet, you
will see 12:00 on the display and the machine is ready
to be set.
2. Please remove the battery tab before use.
GETTING STATRED
Notice：
•If the display is “blank” after plugging in, please check
whether the DISPLAY DIMMER on the back is at the
HIGH position.
•Under the battery power, the display will go blank and
preset alarm will not go off.
•Once the battery is removed and with an interruption of
power, the TIME and ALARM need to be reset when
the power comes back.
6
TIME SETTING
1. Press “ ” button to enter HOUR setting. The
HOUR digits will flash on the display. Press the “ ”
or “ ” button to advance to the correct hour.
2. Press the “ ” button to confirm and enter MINUTE
setting. When the MINUTE digits flash, press the “ ”
or “ ” button to advance to the correct minute.
HOUR Flashes
7
3. Press the “ ” button to confirm and enter Time
Format (12/24H) setting. Press “ ” or “ ”
button to select time format. When using the 12-hour
time format, AM/PM icon will appear on the display to
suggest morning/afternoon time.
4. Press the “ ” button to confirm and exit the Time
Setting Mode.
MINUTE Flashes
Notice：
The machine will exit automatically from the TIME
setup mode if no action is taken within 5 seconds.
(Action refers to pressing the desired button for setup)
8
ALARM SETTING
1. Press the “ ” button to enter ALARM HOUR
setting. The HOUR digits will flash on the display.
Press the “ ” or “ ” button to advance to the
desired hour.
2. Press the “ ” button to confirm and enter ALARM
MINUTE setting. The MINUTE digits will flash on the
display. Press the “ ” or “ ” button to advance
to the desired minute.
HOUR Flashes
9
Notice：
The machine will exit automatically from the ALARM
setup mode if no action is taken within 10 seconds.
(Action refers to pressing the desired button for setup)
MINUTE Flashes
3. Press the “ ” button to confirm and enter WAKE
UP SOUND setting. A number will flash on the display.
Press the “ ” or “ ” button to choose from #1)
Bird chirping sound , #02) Piano sound, #03) Beep
sound, #04) Ocean sound or #05) Brook sound.
4. Press the “ ” button to confirm and exit from
Alarm Setting Mode.
10
ALARM VOLUME SETTING
When sound machine is OFF, press the “ ” or “ ”
button to select the volume level. (0-30 adjustable) A
number will be shown on the display.
Alarm Volume
Notice：
When sound machine is OFF, this alarm sounds has a
5 second trial sound, you can confirm the ringtone you
want in advance by pressing the “ ” or “ ”
button.
11
When the alarm goes off, you have two options:
1. Press “ ” button to stop the alarm when it’s ringing.
Alarm will go off on the next day.
2. Press “ ” button to snooze, the indicator “ ”
will flash on the display. The alarm will go off again 9
minutes later.
ALARM PAUSE & SNOOZE
Press the “ ” button to turn on alarm. Press and hold
the “ ” button for 2 seconds to completely turn off
alarm and the indicator “ ” will disappear on the
display. The alarm will NOT go off on the next day.
ALARM ON/OFF
Notice：
The alarm will automatically turn off after 30 minutes if
no action is taken.
12
2. Press the “ ” button to decrease the volume.
Press the “ ” button to increase the volume.
(0-30 adjustable)
SOUND MACHINE SETTING
1. Press the “ ” button, sound machine will be
ON/OFF.
Sound machine ON/OFF
Notice：
When sound machine is on, the volume adjustment is
only used for sound machine, the volume of the alarm
will not be affected.
13
PICKING YOUR SOUNDS
When sound machine is on, press the “ ” and “ ”
button to switch among 18 sounds in sequence.
Here is the list of tracks
1
2
3
4
5
6
7
8
9
Ocean
Lullaby
Waves
Rain
Thunderstorm
Brook
Shush
Bird chirping
Summer night
10
11
12
13
14
15
16
17
18
Campfire
White Noise 1
White Noise 2
White Noise 3
White Noise 4
White Noise 5
Fan 1
Fan 2
Fan 3
14
The memory function will save your last sound and
volume when you turn sound machine off. Your last
sound machine settings remain saved when you turn it
on next time.
MEMORY FUNCTION
You can use sleep timer to turn off nightlight and sound
machine automatically when the preset sleep timer
comes.
1. Press repeatedly the “ ” button to select the sleep
timer ranging from 15, 30, 60, 90,120 minutes to OFF.
The sleep timer will be shown on display.
SLEEP TIMER
Sleep Timer, 15 minutes
15
2. When the sleep timer is set, please wait for 5 seconds
to exit from the setup. The “ ” indicator will be
seen on the display.
3. Press and hold the “ ” button for 2 seconds to
turn off sleep timer.
4. When sleep timer is on, press “ ” button to see the
sleep timer remained.
Nightlight ON/OFF & Change Color
1. Press the “ ” button to turn on the nightlight. Then
press the “ ” button to change the color of the
nightlight.
NIGHTLIGHT SETTING
16
Slide the DISPLAY DIMMER slider at the back of the
machine to adjust the display brightness. (It can be
adjusted from 0 to 100%)
DISPLAY BRIGHTNESS SETTING
Install 1* CR2032 battery into Battery Compartment.
(Battery is built in already)
BATTERY OPERATED SETTING
2. Press and hold the “ ” button for 2 seconds, the
nightlight will be turned off.
Notice：
Under the battery power, the display will go blank and
preset alarm will not go off. Battery backup is for saving
TIME/ALARM settings only.
17
The sound machine with alarm clock comes with one
year warranty. If you have any issue with this machine,
address your issue within 24 hours.
SUPPORT
Table of contents
