Howard Miller 615010 User manual

4- SHORT
SCREWS
HOWARD MILLER
MODEL 615010
ASSEMBLY INSTRUCTIONS
PARTS LIST:
8- LONG
SCREWS 1- CLOCK DIAL
ASSEMBLY
1- LARGE BASE RING
1- SMALL BASE RING
7. Hook the large curl of the third leg
around the small base ring.
4. Using the same procedure as in
steps 2 and 3, attach the second
leg, adjacent to the first leg.
5. Place the large base ring over the
outside of the legs, inside of the
small curls of the legs.
LARGE BASE RING
6. Place the small base ring inside of
the large curls of the two legs.
SMALL BASE RING
8. Lift the large base ring and slide
the small curl of the leg under the
ring.
9. Using a short screw attach the
third leg to the clock dial assembly.
1. Place the clock dial assembly
upside down on a soft clean
surface.
3. Using a short screw attach the leg
to the clock dial assembly.
2. Align the hole in the top (small curl
end) of of the legs with one of
the four holes in the outside ring of
the clock dial assembly.
one
ALIGN
HOLES
4- RUBBER
PADS
1- GLASS TOP
(NOT SHOWN)
4- LEGS
NOTE: Do not completely tighten screws until all parts have been assembled, step 13.
Do not push or lean on the back of the dial when assembling.

13.Tighten all 12 screws used to
attach the legs, clock dial
assembly, and base rings.
15.Place the glass top on the rubber
pads, centered on the base.
10.Use the same procedure in steps
7, 8, and 9 to attach the fourth leg.
11.Align the holes in large base ring
with the holes in the legs. Using
the long screws attach the ring to
the legs.
12.Align the holes in small base ring
with the holes in the legs. Using
the long screws attach the ring to
the legs.
Note: The holes in the ring may not align perfectly with the holes in the legs and you
may need to apply moderate force to the ring or leg in order to start the screws.
©Copyright 2001 Howard Miller Clock Company
PD10063-R2
10/10
14.Turn the assembled base over so
that the dial is facing up. Attach
the rubber pads over the screw
holes in the outer ring of the base.
RUBBER PAD