Howard Miller 615096 Installation manual

2321581-r1
07/2018
615096 FLOOR CLOCK
SET UP AND OPERATING INSTRUCTIONS
CLOCK ASSEMBLY PARTS
Mid-Collar Assembly
Lower Wood Post
Base
Head Assembly

2321581-r1
07/2018
615096 FLOOR CLOCK
SET UP AND OPERATING INSTRUCTIONS
Page 2
CLOCK SET UP INSTRUCTIONS
1. Remove Twist Ties from Head Assembly.
Twist Ties
2. Remove Front Grill from Head Assembly by
gently pulling away from the Ball Detents.
Twist Ties
Ball Detents
5. Place Base in final location. Place the Lower
Wood Post onto the Base while aligning the Pin
with the Hole in the Base.
IMPORTANT: ENSURE BASE IS POSITIONED
SQUARE AND FIRM ON THE FLOOR SO THAT IT
WILL NOT TIP OVER.
Base
Lower
Wood Post
Hole
Pin
3. Remove Twist Tie and packaging material from
clockhands.
4. Reassemble Front Grill by snapping it over the
Ball Detents.
Packaging Material

Head
Assembly
Head
Assembly
Mid-Collar
Assembly
Mid-Collar
Assembly
Lower Wood Post
Adjust
levelers Base
9. Assembled clock. Adjust levelers (not shown)
on bottom of Base so that the center pole is
vertical.
2321581-r1
07/2018
615096 FLOOR CLOCK
SET UP AND OPERATING INSTRUCTIONS
Page 3
6. Slide Mid-Collar Assembly into Lower Wood Post.
Lower Wood Post
Mid-Collar Assembly
Mid-Collar Assembly
Base Base
Lower Wood Post
7. Screw Mid-Collar Assembly into the Base by
turning clockwise.
8. Screw Head Assembly into the Mid-Collar
Assembly by turning clockwise.

2321581-r1
07/2018
Page 4
615096 FLOOR CLOCK
SETUP AND OPERATING INSTRUCTIONS
615096 FLOOR CLOCK
SETUP AND OPERATING INSTRUCTIONS
11. Install one “AA” size alkaline battery according
to the +/- symbols in the battery holders. Turn the
Time Setting Dial to rotate the hands to the
correct time.
Time
Setting
Dial
IMPORTANT: KEEP PLASTIC BAGS AND
SMALL PARTS AWAY FROM CHILDREN.
10. To access Clock Movement, remove (2) Thumb
Screws at the 3 o’clock and 9 o’clock position on
the back of the Head Assembly.
Thumb
Screw