HP 4430 User manual

One Blue Hill Plaza, 16th Floor, PO Box 1546
Pearl River, NY 10965
1-800-PC-AMERICA, 1-800-722-6374
(Voice) 845-920-0800 (Fax) 845-920-0880
HP 4430 2D Imaging Barcode Scanner
This document contains barcodes for resetting the HP USB Barcode Scanner to factory defaults and for
simulating a carriage return (pressing the Enter key). You can also configure the barcode scanner to
scan Driver Licenses.
Note: This barcode scanner has to ability to scan barcodes directly from a computer screen.
HP Part Number: BW868AA

2
Resetting the HP 2D Imaging Barcode Scanner to Factory Defaults
Scan this barcode to reset all scanner parameters to factory defaults:
Note: Scanning the “Set All Defaults” barcode
does not change the interface type
Simulating Carriage Return (Enter Key)
If a carriage return/enter is required after each scanned bar code, scan the following bar
codes in order:

3

4

5
Driver License Configuration Barcodes
Scan the following barcodes in order. This will configure the barcode scanner to scan Driver Licenses.
Enter Configuration
Advanced Formatting/ Label Edit Script Enable: Enabled
Line 1

6
Line 2
Line 3
Line 4
Line 5

7
Line 6
Line 7
Line 8
Line 9

8
Line 10
Line 11
Line 12

9
Line 13
Line 14
Line 15
Line 16

10
Line 17
Line 18
Line 19

11
Line 20
Line 21
Line 22

12
Exit Configuration

13
Enable Stand Mode
Enable Stand Mode programs the imager to operate in stand mode, where the scanner automatically
senses and reads labels with no trigger pull required.
Configuration in CRE/RPE
Now, you need to enable CRE/RPE to recognize
the specific ID Scanners.
1. Select Manager/Options (enter credentials) >
Setup > Setup Screen
2. Select the Hardware tab, then Page 2
3. Under ID Scanner, select Metrologic
Focus/Genesis Imager
4. Select Update to save changes