HP F1798 User manual

BatteryShip.com
F1798 HP Jornada 520, 525 Series Battery Installation Instructions
PLEASE NOTE: Patience and care, along with moderate technical and hand tool ability, are required for the successful
replacement of a PDA battery. Excessive force may result in damage to your PDA. The instructions below come with
no warranty or guarantee. By utilizing these instructions, you agree to hold Batteryship.com blameless and unaccountable
for any and all damages, problems, or personal injuries that may or may not arise by your use of these instructions.
Replacing your Jornada battery may void any warranty you have on your Jornada. Please read all instructions and
back up your data BEFORE replacing the battery.
Included Phillips Screwdriver Included Plastic Flathead Screwdriver
Step 1.
Remove the four screws on the back of the PDA using the included
Phillips screwdriver. Set the screws aside for reassembly.
Step 2.
Once the screws have been removed, GENTLY
pry open the Jornada case (starting at the top, as
shown) using the included plastic screwdriver. Pry
around the device until the back cover comes open
completely.
Step 3.
Remove your old battery from its seat, using the enclosed plastic
flathead screwdriver to assist (as shown) if necessary. Leave the
connector plugged in for this step. The battery may be glued in,
so pry under it GENTLY until it comes loose. Take care not to break
the old battery while removing it.
Step 4.
Disconnect the old battery at the connector by
CAREFULLY pulling outward on the connector
with your thumb and forefinger or tweezers. Be
very sure that you are pulling outward on only the
part of the connector that comes out, as shown,
NOT on the whole connector.
(Steps 5 & 6 continued on back)

Step 5.
Making sure that your battery is facing the right direction, connect the new battery by pressing the connector at the end of
the ribbon cable into the socket as shown. Note the location of the prongs in the socket of the Jornada and the location of
the plugs for the prongs on the battery connector, and connect them accordingly. Do not press too hard or try to force the
pieces together. They will fit easily when correctly aligned. Place the new battery in its seat.
Step 6.
Press the back cover of the Jornada on over the new battery, making sure that the scroll wheel shows through (as
shown), and screw the four screws back in. FULLY CHARGE your new battery before use. (Allow at least three hours. For
quality control, we pre-charge many of our batteries, so yours may require less time.)
PLEASE NOTE: Our tools fit the majority of Jornadas, but some devices may have different screws installed for
various reasons. If our tools do not fit your device, you may have the appropriate tool in a tool kit you already
own. You can also check your local hardware or electronics store if you do not have the right tool at home.