Hubbell AccelTex ATS-NL-IC-ENC-15153 User manual

Step 1
Cut a square hole in the ceiling according to the
dimensions in the drawing below.
Step 2 Separate the cover from the metal AP
mounting box using the provided allen
wrench.
Installation Guide
ATS-NL-IC-ENC-15153
Introduction
This is a quick guide for the AccelTex
15”x15”x3” Non-Ligature Enclosure. This can
be flush mounted in a ceiling or a wall.
The facts and figures herein are carefully compiled to the best of our knowledge and
are intended for general informational purposes only. Responsibility for the use and
application of AccelTex Solutions materials rests with the end user ©2023 AccelTex
Solutions. All Rights Reserved.
1.888.406.8906
[email protected]

Installation Guide
ATS-NL-IC-ENC-15153
Step 4 Fit AP mounting box into pre-cut
hole in the ceiling/wall and secure
by turning the mounting tab screws
to lock into place.
Step 5
Plug ethernet cable
into AP. Mount the
AP on the provided T-
Bar mount and
reinstall cover with 4
screws using the
provided allen
wrench.
Step 3 Feed ethernet cable into box through the standard cord grip.
The facts and figures herein are carefully compiled to the best of our knowledge and are intended for general informational
purposes only. Responsibility for the use and application of AccelTex Solutions materials rests with the end user ©2023
AccelTex Solutions. All Rights Reserved.
1.888.406.8906 / [e-mail]