Human Solution INNOVATIVE 9109 User manual
Model 9109
Single or Double LCD Stand
Installation Instructions
Ergonomic mounting solutions for monitors and keyboards.
IOP-502574
Step 4 Monitor to Pole Assembly
Step 5 Tilt Mechanism Adjustments
Your assembly and modificationsarecomplete.
After securing the plate to the flat panel insert the tilter into the arm.
Screw the 10-32” Philips Pan Head screw and washer and fasten them to the
hole in the underside of the tilter shaft, locking the monitor in place.
Tilt the monitor so it faces upward and locate the set screw under the tilter.
Insert the 7/32” Allen wrench into set screw to adjust the tilt friction.
* To tighten friction turn the wrench to the right.
* To loosen, turn the wrench to the left.
Step 1 Pole/Stand Assembly
Single: Insert the pole into the stand and tighten set screw in back of stand using the
7/32 allen wrench.
Double: Follow above step, insert the second pole inside the first pole at preferred height
and tighten the set screws with the 3/32” allen wrench that is provided.
Set
Screw
Single
Double
Set
Screw
Step 1A Collar Adjustments
Loosen the knob on the back of the collar so that the collar is able to slide up or down. Find
the desired height and re-tighten the knob.
*If you are assembling the Double, do this for both upper and lower knobs.
Tension
Knob
Step 4 Attach Tilter/VESA bracket to the monitor
Carefully remove the base from the flat panel monitor. (See your monitor’s User’s Guide
for instructions on how to do this.)
Attach the adapter plate (75MM or 100MM) to the tilter mechanism, using four (4)
10-32 x 3/8” Flat Head Philips screws.
Step 3 VESA Bracket & Tilt Mechanism Assembly
Align the tilter and VESA bracket with the hole pattern on the back of the monitor.
Use the four (4) M4-12 Philips Pan Head screws to attach the plate to the back of the LCD.
if your monitor is not VESA compliant.
Table of contents
