Humanscale Quickstand User manual

INSTALLATION INSTRUCTIONS
Freestanding Base
PARTS REQUIRED
A (1) QuickStand Unit
B (2) Leg-Covers
C (1) Stopper
D (1) Leg
E (1) Base
F (1) Spacer
G (1) Platform (work surface)
H (8) M6 x 9.5 mm Flat Head Machine Screws
I (6) M8 x 18 mm Flat Head Machine Screws
J (2) M8 x 14 mm Button Head Machine Screws
4 mm Hex Key (supplied)
5 mm Hex Key (supplied)
6 mm Hex Key (supplied)
A
E
F
G
H
I
J
B
C
D
Hardware
Tools Required

2
Read all instructions carefully before installing this product or attempting to use it
This product contains a loaded mechanism that is under tension. Do not attempt to
remove or alter any part of this product or in any way modify or tamper with any
component of this product other than as set forth in these instructions. Failure to
comply with the instructions provided may result in property damage or serious injury.
Do not remove bracing box attached to QuickStand unit until your QuickStand is
fully assembled
WARNING
B
A
STEP 1
Assemble Post
Tools: 5 mm Hex Key
• Place the base on the desk and remove the leg (fig A)
by unscrewing the two screws and set them aside
for use in step 6.
• Place the QuickStand post
on the desk laying on its back.
• Carefully remove the shipping plate (fig B)
and set aside the (2) M8 x 10 mm Cap
Head Machine Screws and the
Washers for Step 4.
IMPORTANT: DO NOT
REMOVE BRACE BOX!

3
STEP 2
Install Leg
Tools: 5 mm Hex Key
• Secure the leg in place using
(6) M8 x 18 mm Flat Head Machine Screws
(fig. C)
• Attach stopper using (2)
M8 x 14 mm Button Head Machine Screws (fig D)
and make sure the edge is parallel with the base
STEP 3
Attach Platform
Tools: 6 mm Hex Key
• Ensure the Platform is parallel and equally spaced
from the leg on either side (fig. E)
• Using the (2) M8 x 10 mm Cap Head Machine
Screws and the Washers from step 1, secure
the Platform to the QuickStand unit
C D
STEP 4
Attaching Spacer Under the Platform
• Peel back paper to expose adhesive and press the spacer
firmly into place on the underside of the Platform
centered and parallel to the pads (fig. F)
F
Leg
Platform
E

www.humanscale.com
HSFBI1015
Customer Service: N America [phone] / International [phone]
STEP 6
Attach Leg to Base
Tools: 4 mm Hex Key
• Secure the legs to base using (8)
M6 x 9.5 mm Flat Head Machine Screws (fig. I)
• Attach the plastic leg-covers by pressing firmly
down until they each click into place (fig J)
• Position the unit so the front edge of the
work surface aligns with the front edge of
the desk when in the low position (fig K)
Proceed to the Monitor Installation steps in the main QuickStand Assembly Instructions
I
J
K
STEP 5
Attaching QuickStand to the Base
IMPORTANT: Your QuickStand unit is heavy. If needed, please
have assistance when lifting.
• Carefully lift your QuickStand unit from its horizontal position
to its vertical position (fig. G)
• Once your QuickStand is sitting upright on the base slide it
back so the stopper hooks into base (fig H)
H
G