Humanscale Quickstand User manual

Grommet Mount/Bolt-through Kit
www.humanscale.com
HSQSGMI1114
Customer Service:
N America [phone]
International [phone]
Grommet Mount/Bolt-through Parts
A (1) Grommet Base
B (1) Base Plate
C (2) M8 Flange Nut
D (1) Pair Bolt
Tools Required
E Tape Measure
F 5 mm Hex Key
STEP 4
Cable Management
• If running QuickStand cables through the grommet hole in the work surface
install only the front cable tab onto the bottom of the Bolt-Mount (fig. G)
• If running the QuickStand cables over the back of the work surface install
both cable tabs onto the bottom of the Bolt-Mount (fig. H)
G
E
A
D
C
B
F
H

STEP 1
Preparing the Work Surface
Tools: Measuring Tape
• If using a grommet hole, drill a hole 2” (51 mm) minimum in diameter and
5” (127 mm) minimum from the rear of the work surface to the center of
the grommet hole. (fig. A)
• If using bolt holes, drill two holes 1/2” (13 mm) in diameter and 1.2”
(30 mm) apart from each other and 5” (127 mm) minimum from the rear
of the work surface to the center between the two bolt holes. (fig. B)
• Measure from the front of work surface to the center of grommet hole
or directly between the two bolt holes. (fig. C) This measurement will be
required in Step 3
STEP 2
Remove Base Clamp
Tools: 5 mm Hex Key
• Carefully place the QuickStand down onto the work surface as shown in
(fig. D). Remove the (4) M8 x 10 mm Pan Head Machine Screws to remove
the Base Clamp
STEP 3
Installing Bolt Mount
Tools: Measuring Tape
5 mm Hex Key
• Place the Bolt-Mount onto the QuickStand base and position it so that the
distance between the front edge of the platform to the center of the pair-bolt
(fig. E) is equal to the measurement taken in Step 1. (fig. C)
• Attach the Bolt-Mount using the (4) M8 x 10 mm Pan Head Machine Screws.
(fig. F)
A
CCB
1.2”
(30 mm)
5”
(127 mm )
5”
(127 mm )
D
E
F
Position pair-bolt here for surface’s
30” (800 mm) or less
Position pair-bolt here (shown) for surface’s
greater than 30” (800 mm)