Humanscale Thin Client Holder User manual

INSTALLATION INSTRUCTIONS
Thin Client Holder
Included Hardware
Beam Mount Kit (optional)
Tools Required
Surface Mounting
Screws
5mm Hex Key Mounting Cleat
Beam Bracket
Cable Management
Clip
Drill with Phillips Head
Driver Bit
Beam Mounting
Screws
HSIMTCD0120
STEP 6:
If needed, the cable management clip
can be used to organize cables exiting
the thin client.
North America: [phone]
Europe: [phone]
Asia Pacic: [phone]
www.humanscale.com
For our terms and conditions please go to
https://www.humanscale.com/about/legal-information/terms-conditions.cfm
© 2020 Humanscale Corporation. The text and artwork are copyrighted materials. All rights
reserved. The Humanscale mark and logo are trademarks of Humanscale Corporation and are
registered in the United States and certain other countries.

STEP 1:
STEP 4 (If using Beam Mount):
STEP 2:
Using the included 5mm hex key, loosen the
adjustment screw to pull the two halves apart.
Insert your thin client into the holder with the front
facing the same side as the Humanscale logo.
Squeeze the two halves of the holder together and
re-tighten the adjustment screw.
STEP 3:
Remove the mounting cleat from
the thin client holder.
Using the two M5 screws, attach the mounting cleat to the beam
bracket.
Then, using the 4 mounting screws, attach the beam bracket under the
desk in the desired location. Ensure that there is enough clearance on
all sides for the thin client and holder.
STEP 4 (If using Surface Mount):
Using the included screws, attach
the mounting cleat under the desk
in the desired location. Ensure that
there is enough clearance on all
sides for the thin client and holder.
STEP 5:
Slide the thin client and holder onto the
mounting cleat until it clicks into place.