Hummingbird Playground Fountain User manual

Tabletop Instructions:
The top cover should have three copper outlets on the underside of
the pump, these outlets are attached to plastic tubing, adapter
tubes, and 2-Tee connectors creating a distribution manifold.
One Tee has a perpendicular black tube about 3" long, this Tee is the
connection to the pump.
Use the 1/2" straight connector that comes with the pump. Insert
the long end of the connector into the black tube the short side of
the
fitting
goes
into the
pump.
The pump should remain attached to the tube when the top is
placed onto the base.
Hold the pump cord into the slot at the rear, and set the top onto the
base.

The flowers slip onto the copper supports on the top of the
fountain. There are 3 different lengths so the flowers overlap each
other at different heights.
The center should be the tallest and installed last , placing the left and right flowers first is the easiest method of setting the
flowers into place.

The pump has a flow adjustment
Trap Door for filling fountain.
"Hummingbird Playground Fountain"
Tabletop Fountain
www.hummingbird.toys/tabletop.html
Copyright Gary E Hartz 2018
All Rights Reserved