HUTTON WYC User manual

garden and landscaping products
HH
UTTOUTTO
NN
Assembly Instructi ns
WYC – Circular Picnic Table
1. Please allow enou h time and be patient when assemblin
your table.
2. Sort out all components as sketch before you start.
3. Place the table top upside down on a flat surface, takin care
to protect the top from scratchin .
4. Take each le in turn and assemble to top as shown on sketch,
push caps into the le , passin bolt throu h block and screw
into le . Do not ti hten completely at this sta e.
5. Repeat for all four le s.
6. Take the two cross rails (Type A) and fit to le s as shown in
sketch.
7. Repeat for other two cross rails (Type B). Pass bolts throu h
cross rails and le s into cap in outside of cross rail. Do not
ti hten completely at this sta e. Note: Small rebates face
inwards to support parasol.
8. Slot seats, face down, between cross rails and pass lon bolts
throu h rails and seat battens and screw into rail caps. Do
not fully ti hten at this sta e.
9. Repeat for all four seats.
10. Select two braces and position as sketch. Pass a 60mm bolt
throu h brace and screw into insert on seat.
When assemblin , loosely
bolt to ether until fully
assembled then ti hten all
the bolts.
List of parts in fixings pack
20 x M8 95 B lts
16 x M8 60 B lts
28 x M8 25 Caps
2 x Allen Keys
During the treatment pr cess, s me
grain may be raised - y u can
enhance y ur table by a little fine
sanding f the edges.
continued overleaf

Hutton Garden and Landscaping Products
Church Lan , Northwood Gr n, W stbury-0n-S v rn, Glouc st rshir GL14 1ND www.s w2000.co.uk/hutton
T l: 01452 762089 Fax: [phone] sal [e-mail]
garden and landscaping products
HH
UTTOUTTO
NN
Assembly Instructions
WYC – Circular Picnic Tabl
11. R p at with th oth r brac with th nd against th l g, and
th n pass a 95mm bolt through first brac through l g and
scr w into a cap plac d in s cond brac .
12. R p at for oth r thr s ats.
13. With all compon nts now ass mbl d, go round and fully
tight n all 36 bolts with All n k ys provid d.