HydroHoist UltraLift Series User manual

Rev B 08062020

2
HYDROHOIST, LLC PRODUCT INSTALLATION AND USE WARNING DISCLAIMER
Assembly, installaon, or repairs of a HydroHoist Boat Li should only be performed by an authorized
HydroHoist technician. If assembly, installaon, and/or repair is performed by an unauthorized person(s),
serious personal injury and/or property damage could occur.
If unauthorized personnel assemble, install, or repair a HydroHoist Boat Li, HydroHoist, LLC hereby
disclaims any and all warranes, express or implied. HydroHoist, LLC limits its warranty to HydroHoist,
LLC’s published boat li warranty furnished with each product. No other warranty of any kind, either
verbally or implied, including warranes of merchantability and tness for a parcular purpose are
recognized.
The contents of this manual are subject to change without noce and should not be construed as a
commitment, representaon, warranty, or guarantee of any method, product, or device by HydroHoist,
LLC.
Reproducon or translaon of any part of this manual, without the wrien permission of HydroHoist, LLC
is prohibited.
Any inquiries concerning HydroHoist, LLC’s published warranty or this manual and its contents should be
referred to:
HydroHoist, LLC
915 West Blue Starr Drive, Claremore, OK USA 74017
[phone] • Oce hours: Monday-Friday, 8:00 a.m. to 5:00 p.m. CT
SAFETY NOTICE
To ensure consumer safety, HydroHoist, LLC has installed in the control unit’s electrical system an AC
Ground Fault Circuit Interrupter (GFCI) device which is to be used in series with the user’s primary AC
power source. The GFCI is an integral part of the HydroHoist boat li and is designed to oer a limited
measure of protecon to the user against hazardous electrical condions or shocks should they occur.
WARNING!
If the user disables the control unit’s Ground Fault Circuit Interrupter (GFCI) Device, they are in direct
conict with the recommendaons of the United States Government Consumer Products Safety
Commission. Disabling the GFCI could result in severe electrical shock or death.
Before connecng AC power to the control unit, be certain that the primary AC power supply meets all
applicable electrical codes.
Any inquiries concerning the Ground Fault Circuit Interrupter (GFCI) device should be referred to
HydroHoist, LLC.

3
Control Conguraons and Funconality
The UL Triton Control can be ulized on the following models of HydroHoist products:
• ULTRALIFT™ 4,400, 6,600, & 8,800
• SHALLOW WATER
• FRONT MOUNT
• E-SERIES
Basic Funconality
To Raise the Vessel:
1. Posion the boat directly over the hoist using guide ropes
2. Press the RAISE buon
3. Once the boat is fully raised and bubbles are exhausted from the tanks, press the STOP
buon
To Lower the Vessel:
1. Press the LOWER buon
2. 2. You can press the STOP buon at any me to pause the raise or lower process.
If you want the valve to be closed when the li is in the lowered posion; press the
STOP buon.
IMPORTANT: WHEN PLUGGING IN THE CONTROL THERE WILL BE A 5 SECOND
DELAY BEFORE THE CONTROL IS READY FOR USE. THIS ALLOWS THE SYSTEM
TIME TO BOOT UP.

4
Basic Operaons
Raise Mode turns blower on and acvates valve system to li the vessel
• Power LED is solid GREEN during this mode
• Raise Mode will automacally shut o aer 10 minutes if STOP is not
pressed
Lower Mode acvates valve system to lower the vessel
• Power LED is solid GREEN during this mode
• Lower mode will automacally shut o aer 10 minutes if STOP is not
pressed
Stop Mode shuts all valves and veries blower is o
• Power LED is solid RED in this mode
Factory Resets
• Press and hold the STOP buon down for 10 seconds
• Power LED will ash GREEN 3 mes indicang the reset has
completed
• Restores all sengs to factory and erases Boarding Height and
Raise mers back to factory level reference

5
Set Boarding Height Timer allows you to lower the vessel to a set height o the water
to load or unload your vessel while the li holds the vessel from oang away
Important: This feature MUST be set or used from the fully raised posion with ONLY
the boat on the hoist.
• Instrucons to set Boarding Height Timer: Press LOWER and wait unl the vessel
reaches the desired boarding height. Once the desired boarding height is reached,
press and hold LOWER buon for 3 seconds.
• Power LED will ash GREEN 3 mes indicang the boarding height mer is set.
• To acvate Boarding Height Mode: Press and hold LOWER for 3 seconds.
Remember, this feature MUST start from the fully raised posion. The Power LED
will turn solid BLUE indicang you are in Boarding Height Mode. It will run the
amount of me set from the above step and then return to STOP Mode. You can
also press STOP at anyme to cancel boarding height.
Clear Boarding Height Timer
Important: To set a new Boarding Height Timer you must rst clear the old mer.
• Press and Hold the LOWER and STOP buons together for 3 seconds
• Power LED will ash GREEN 3 mes indicang it has been cleared
Set Raise Timer allows you to set a less amount of me for RAISE MODE other than the
default 10 minutes. Ideal feature for solar or baery opon to save power
Important: This feature MUST be set when the li is completely lowered
• To set: Press RAISE then wait unl the vessel is completely up and all tanks are
bubbling and allow it to run an addional 30 seconds
• Then Press and Hold the RAISE buon for 3 seconds
• Power LED will ash 3 mes GREEN indicang the Raise Timer is set
Clear Raise Height Timer
Important: To set a new Raise Height Timer you must rst clear the old one
• Press and Hold the RAISE and STOP buons together for 3 seconds
• Power LED will ash GREEN 3 mes indicang the mer has been cleared
Advanced Funconality of the Control

6
The Triton UltraLi Series Control is equipped with a Manual Override for lowering the li. This would be
used if there is loss of power to your control and you need to lower your vessel.
Instrucons for manually lowering:
1. Locate Pull Steam Knob on the side of the valve located on the backside base of the control. There may
be tamper proof tape over it. If so, remove the tape.
2. To open the valve manually, pull the knob out.
3. Start rotang the knob either direcon. Rotate 5 to 10 rotaons unl the valve is fully open. As it starts
to open, you will start to hear the air release through the exhaust port.
4. When the li is all the way down, push the knob back in completely, thus automacally shung the
valve.
IMPORTANT: IF THE VALVE KNOB IS NOT COMPLETELY PUSHED IN, THE VALVE WILL NOT FUNCTION
NORMALLY WHEN POWER IS RE-SUPPLIED TO THE CONTROL.
Manual Lowering of Vessel “Manual Override”
Manual Override instrucons on base Pull Stem Knob & Rotate

7
Guide Rope Mooring Rope Soluons

8
Guidelines When Operang Your Li D
DO’s: ON’T
• Always use guide ropes. They are required for proper posioning of the boat and if they are not used
(for those applicaons specied in this instrucon manual) your warranty is void.
• Always raise the hoist if it is not used for an extended period of me (more than a day), or if the water
is rough. The hoist will survive storms and rough water much beer in the raised posion.
• Secure the boat to the boat dock or landing in case the hoist is accidentally lowered in your absence.
• Leave your boat on the hoist during winter, if you desire. Staonary ice will not damage the hoist if it
is up.
• Follow the instrucons in this manual and your hoist will give you years of trouble-free service.
DO NOT’s:
• Do not push back excessively on the boat while the hoist is liing. Push back just enough to ghten the
Guide Ropes and only unl the hoist makes contact with the boat.
• Do not aempt to raise any boat other than the one for which the hoist was built for. Hoist or boat
damage can occur. Your dealer can make adjustments to the hoist for a dierent boat.
• Do not grease the hoist. Lubricaon is NOT required.
• Do not allow anyone in the boat during the liing or the launching operaon.
• Do not secure any part of the boat, boat accessories, or boat cover to the li.
Warning: Hoist is installed as either a pull-in or back-in. For safe operaon, the boat can-
not be loaded opposite to how the hoist is installed.
Contact HydroHoist, LLC for any addional accessories and products at www.boatli.com.

9