Hyundai Mobis FOB-4F04 User manual

Hyundai MOBIS Co., Ltd.
FOB-4F04 Remote Keyless Entry
User Manual
OUTLINE
1. How to use FOB-4F04
- FOB-4F04 is Remote Keyless System.
- This unit controls door lock/unlock/trunk with wireless.
2. Introduction of Transmitter (FOB-4F04)
- Transmitter has three buttons
- Transmitter use the battery
- Frequency is 433.92MHz
GENERAL DESCRIPTION
PRIMARY FUNCTION
- Remote door lock/unlock/trunk
- Operating distance : over 30m
- Id input (setting mode)
Manual
1) LOCK Button
If the LOCK button is pushed over 30ms, then TRANSMITTER sends the LOCK Data.
2) UNLOCK Button
If the UNLOCK button is pushed over 30ms,
then TRANSMITTER sends the UNLOCK Data.
3) TAILGATE Button
If the TAILGATE button is pushed over 1000ms,
then TRANSMITTER sends the TAILGATE OPEN Data.

FCC Warning
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
■Reorient or relocate the receiving antenna.
■Increase the separation between the equipment and receiver.
■Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
■Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void
your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.