I MUST SCREAM 110 User manual

I MUST SCREAM
DUAL VOLTAGE CONTROLLED GATE MODEL 110
ASSEMBLY GUIDE
imustscream.cc

The kit consists of PCB, Panel, 3 bags of components (A, B, C) and
knobs.
Bag (A) contains: resistors, all numbered by their values
Bag (B) contains: Capacitors, Trimmers, Transistors. Pay attention to the matched
transistors pairs: (T1 T2) and (T8 T9)
Bag (C) contains: Jacks, Potentiometers, Banana Jacks, Standoffs, Wire, Pins.
Please refer to BOM for components placing.

Step 1
Solder all the resistors.

Step 2
Solder all the transistors. Pay attention to the orientation. The flat side
has to match with the flat side on the silkscreen.
Solder matched pairs in their corresponding places.

Step 3
Solder 2 red unpolarized capacitors. Orientation here doesn’t matter.

Step 4
Solder polarized capacitors. Orientation here DOES matter. Refer to
silkscreen + sign.

Step 5
Solder trimmers. Pay attention to the orientation. You can refer to the
silkscreen or this photo.

Step 6
This step is (optional). Otherwise, you can solder wires directly.
However, I strongly recommend using pins.

Step 7
Secure the banana jacks on the front panel.

Step 8
Position jacks, potentiometers and standoffs. Don’t solder yet. Secure
them to the front panel, and tighten. Solder AFTER tightening.

Step 9
Cut and strip the wire from the Bag (C).
Insert it in the CV pins.

Step 10
Solder wires to the banana jacks.

Step 11
Now you can put knobs on and prepare for simple calibration.
Congratulations!