iBall Baton iB-LGDS18G User manual

I
User Guide
8-Port Gigabit Desktop Switch
Model No.: iB-LGDS18G
Ver.: 3.0.0

II
FCC STATEMENT
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/ TV technician
for help.

III
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including
interference that may cause undesired operation.
Any changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority
to operate the equipment.
CE Mark Warning
This is a class B product. In a domestic environment, this
product may cause radio interference, in which case the user
may be required to take adequate measures.

IV
Package contents
The following contents should be found in your box:
One 8-Port Gigabit Desktop Switch
User Guide
Power Adapter
Note:
If any of the above listed contents are damaged or missing,
please contact the dealer from whom you purchased the 8-Port
Gigabit Desktop Switch (iB-LGDS18G) for assistance.
Safety Notices
Do not use this product near water. Avoid using this product
during an electrical storm. Do not place heavy objects on the
switch.

1
Chapter 1 Installation
1) Please inspect the Power Adapter carefully, and make sure
that it is properly connected to a power source.
2) Power on. It will be automatically initialized and the LED
indicators should respond as follows:
a) The Power LED indicator will light up.
b) All of the port LED indicators will flash momentarily,
which represents a resetting of the system.
Chapter 2 Features & Specifications
Complies with IEEE802.3u, IEEE802.3ab standards
8 - Port 10/100/1000Mbps Auto-Negotiation RJ45 ports,
supporting Auto-MDI/ MDIX
Supports IEEE 802.3x flow control for full Duplex mode and
backpressure for Half Duplex mode
Non-Blocking switching architure that forwards and filters
packets at full wire-speed for maximum throughput
MAC address auto-learning and auto-aging
Store and forward switching method
Desktop or Wall mount design

Specifications
Standards
IEEE 802.3u 100Base-TX,
IEEE 802.3ab 1000Base-T
Data Transfer
Rate
1000Mbps (Half Duplex),
2000Mbps (Full Duplex)
Protocol
CSMA/CD
Network
Media(Cable)
100BASE-TX: UTP category 5, 5e cable
(maximum 100m)
EIA/TIA-568 100Ω STP (maximum 100m)
1000BASE-T: UTP category 5e, 6 cable
(maximum 100m)
EIA/TIA-568 100Ω STP (maximum 100m)
Number of Ports
8-10/100/1000Mbps Auto-Negotiation ports
LED indicators
Power, LAN LEDs (1,2,3,4,5,6,7,8)
Power Adapter
(Optional)
9V DC, 0.6A
Environmental and Physical
Operating
Temperature
0℃~40℃(32℉~104℉)
Storage Temperature
-40℃~70℃(-40℉~158℉)
Operating Humidity
10%~90% non-condensing
Storage Humidity
5%~90% non-condensing

Chapter 3 Identifying External Components
3.1 LED indicators
Power LED: This indicator will light up when the Switch
powers up.
LEDs (1-8): One LED indicator will light green when a
device is connected to the corresponding port. It flashes
when data is being transmitted or received on the
connection.
3.2 Rear Panel
The rear panel of the iB-LGDS18G consists of 8
10/100/1000Mbps RJ45 ports. All ports can work as the uplink
port.

COPYRIGHT & TRADEMARKS
Specifications are subject to change without notice. iBall Baton
is a registered trademark of Best IT World (India) Pvt. Ltd.
Other brands and product names are trademarks or registered
trademarks of their respective holders.
No part of the specifications may be reproduced in any form or
by any means or used to make any derivative such as
translation, transformation, or adaptation without permission
from Best IT World (India) Pvt. Ltd. All rights reserved.
Note: For any technical help on iBall Baton products please
contact [email protected]
www.iBallBaton.com