iBall Andi4 IPS Tiger User manual

1

2
Legal Information
All rights are reserved. Reproduction, transfer, distribution of the contents
herein in any manner without the prior written permission of Best IT World
(India) Pvt. Ltd. is prohibited. Best IT World (India) Pvt. Ltd. reserves the
right to add, modify or delete, any of the contents herein or withdraw this
document at any time without prior notice and without assigning any
reasons thereof. For detailed terms and conditions refer www.iBall.co.in
Safety Precautions
Operate Safely
• Please do not use Mobile while charging. Disconnect Mobile from charger
before use.
• Make sure to charge the battery full for the first time usage.
• Keep the mobile phone at least an inch away from your body while dialing /
answering calls.

3
• Do not use the mobile phone if the screen is cracked or broken. Cracked
and / or broken screens could cause injury to hands and / or face.
• To reduce the risk of motion injuries:
- While using your mobile phone, hold it with a relaxed grip and press the
keys lightly.
- Do not handle the mobile phone with wet hands.
- Use of special keys / features reduce the number of keys presses
- Take regular breaks in between calls.
- Use hands-free accessories.
- Switch off the mobile phone before cleaning it.
- Switch off the Mobile Phone and external power sources before any
attempt to change batteries, SIM Cards or any other accessories.
- Keep your mobile phone and all accessories out of reach of small children
and animals.
Careful handling

4
• Avoid potential damage to your mobile phones as under:
- Keep away from liquids.
- Avoid using and / or storing in dusty and / or dirty places / environments.
- Do not drop, knock, throw or other wise handle the mobile phone roughly.
- Avoid exposing your mobile phone and / or batteries to extreme
temperatures. Extreme temperatures reduce the charging capacity and life
of batteries and mobile phone.
- Never use damaged chargers or batteries.
- Do not use chemicals or other cleaning solutions to clean the mobile
phone.
- Use moist or anti-static cloth.
- Avoid using mobile phone with camera flash or light close to the eyes.
- Do not dismantle the mobile phone and / or accessories without
permission.
- Avoid handling by unauthorized personnel.

5
Turn Off your Mobile Phone in
Restricted Areas
Use of mobile phones in certain areas / places / conditions can be
hazardous.
• Switch off your mobile phone:
- Inside aircrafts;
- In Medical hospitals / clinics;
- Areas where chemicals are used and / or stored;
- Fuel and gas stations;
- In and around areas having electrical / electronic equipments;
- Areas where any kind of blasting activity is being carried out.
• Removing, installing or charging mobile phone batteries in such areas is
hazardous as potential sparks may result in explosion and / or fire and may
cause damage to property and / or life and can also prove fatal.

6
Drive Safety
Avoid using your mobile phone while driving and respect and obey all
regulations that restrict the use of mobile phones while driving. Primary
consideration while driving should be safety.
Interference with Electronic Devices
Mobile phones emit Radio Frequency (RF) signals that may interfere with
unshielded or improperly
Shielded electronic equipments, such as pace makers, hearing aids, other
medical devices and other electronic devices in homes and / or vehicles and
may prove to be hazardous.
Protect Your Hearing
Excessive exposure to high volumes may cause hearing problems. Maintain
proper volume levels for conversations and / or music.
Use & Dispose of Batteries & Chargers

7
• Use only iBall accessories and batteries. Using incompatible batteries and
/ or accessories may damage your mobile phone or cause injury.
• Never dispose the battery or mobile phone in fire.
• Never crush or puncture the battery.
• Avoid exposing the battery to high external pressure, which can lead to an
internal short circuit.
• Never place batteries or mobile phone in or on heating devices, such as
microwave ovens, stoves or radiators. Battery may explode when
overheated.
In order to use mobile phone correctly, please read the following statement
of the user manual carefully before using the mobile phone.
Using this Guide
This guide has been specially designed to guide you through the basics of
your device, such as getting started with the device. Please read this guide
carefully before using your device to ensure safe and correct use.
The descriptions in this guide are based on the default settings of your
device.

8
INDEX
1. Introduction .......................................................................9
2. Installing SIM, Battery, and Memory card.........................14
3. Using Phone Features.......................................................20
4. Contacts ...........................................................................34
5. Messaging ........................................................................39
6. Setting..............................................................................51
7. Internet ............................................................................79
8. Experiencing Multimedia..................................................86
9. System Applications .........................................................96
10. Google Applications .......................................................107
11. Other Applications .........................................................110

9
1. Introduction
1.1 Andi4 IPS Tiger Technical
Specification
Details Description
CPU
Quad Core 1.3Ghz Cortex A7 advanced Processor
Memory 512 MB RAM
Storage
4GB internal storage (Approx. 2GB built-in Storage is
utilize by OS and application files)
Micro SD Support up to 32 GB
O. S. Android 4.2.2 Jelly bean
SIM Network
Dual SIM Dual Standby, 2G - GSM 900/1800 MHz;
3G - WCDMA 2100 MHz
Sensor G-Sensor
Connectivity
Wi-Fi 802.11b/g/n, Wi-Fi Direct, Wi-Fi Hotspot,
Bluetooth-A2DP, Bluetooth-Tethering, 3G
HSPA+, 21Mbps Downlink & 5.6Mbps Uplink,
EDGE, GPRS, GPS / A-GPS, USB Mass
Storage, USB Internet
Camera Enhanced 5 MP Camera with LED flash

10
Front camera for Video Calling.
Display 10.16 cm (4”) IPS WVGA (800x480) High Quality
Audio Formats Support acc, amr, midi, mp2, ogg, wav
Video Formats Support 3g2, 3gp, avi, m2ts, mkv, mov, mp4, webm
Image Formats Support bmp, gif, jpeg, png, wbmp
Audio Port 3.5 mm stereo jack
FM FM Radio with recording
Soft Keys Menu, Home & Back
Hard Keys
Power and Volume controller
Charging Port Micro USB
Battery
1300 mAh Li-ion
Power 3.7V
Others Feature
Auto Call Recording, Special UI with multiple Theme
Dimension 125.2x64.1x10.6mm
Weight
111.6 gm
Application WhatsApp, Facebook , We Chat and more

11
1.2 Know Your Device

12
1.3 SAR
This mobile phone is SAR accredited adheres to international quality
benchmarks and safety measures concerning the harmful impact of
radiations. It complies with applicable safety requirements for exposure to
radio waves. The radio waves exposure guidelines employ a unit of
measurement called Specific Absorption Rate (SAR). SAR is a measure of
the rate at which energy is absorbed by the body when exposed to a radio
frequency (RF). SAR is usually averaged either over the whole body, or over
a small sample volume (typically 1g or 10g of tissue). The recommended
SAR limit for a mobile handset is 1.6 W/Kg averaged over a volume
containing a mass 1g of human tissue.
SAR Value
• Your phone is designed not to exceed the limits of emission of radio waves
recommended by international guidelines.
• SAR (Specific Absorption Rate) is the measurement of body-absorbed RF
quantity when the phone is in use. SAR value is ascertained according to
the highest RF level generated during laboratory tests.
• The SAR value of the phone may depend on factors such as proximity to
the network tower, use of accessories.

13
SAR Recommendations:
• Use a wireless hands free system (headphone, headset) with lower
Bluetooth emitter.
• Make sure the cell phone has a low SAR.
• Please keep your calls short and use SMS whenever more convenient.
This advice applies especially to children and pregnant women.
• Prefer to use your phone when the signal quality is good.
• People having active medical implants should preferably keep the phone
at least
Tested SAR Value
Tested SAR Value of Andi4 IPS Tiger is as follows:
(2G) GSM 900MHz: 0.261 W/Kg (1g)
(2G) GSM 1800MHz: 0.547 W/Kg (1g)
(3G) WCDMA 2100MHz: 0.546 W/Kg (1g)
Maximum Permitted SAR value is: 1.6 W/Kg (1g)

14
2.Installing SIM, Battery,
and Memory card
You need to remove the back cover before you can install the SIM card and
battery. Also, make sure to always turn off the power before installing or
replacing the SIM card and battery.
To remove the back cover
1. Make sure your device is turned off.
2. Firmly hold the device with both hands and the front panel facing down.
3. Push the back cover up with your thumbs until it disengages from the
device and then pull it up to remove.
2.1 Install SIM card
The SIM card contains your phone number, service details, and phonebook/
message memory. Your device supports both 2G and 3G (WCDMA) SIM
cards.

15
1. Remove the battery if it is installed.
2. Locate the SIM card slot, and then insert the SIM card with its gold
contacts facing down and its cut-off corner facing out the card slot.
3. Push the SIM card completely into the slot.
If you need to use 3G operation, please insert 3G SIM card in the SIM slot &
Enable 3G services for the appropriate SIM (Settings/More…/Mobile
networks/3G service).
Some legacy SIM cards may not function with your device. You should
consult with your service provider for a replacement of SIM card. There may
be some fees for this service.
2.2 Install Battery
Your device comes with a rechargeable Lithium-ion battery and is designed
to use only manufacturer-specified original batteries and accessories.
Battery performance depends on many factors, including network
configuration, signal strength, and usage patterns.
Warning: To reduce risk of fire or burns:
• Do not attempt to open, disassemble, or service the battery pack.

16
• Do not crush, puncture, short external contacts, or dispose of in fire or
water.
• Do not expose to temperatures above 60°C (140°F).
• Replace only with the battery pack designated for this product.
• Recycle or dispose of used battery as stipulated by local regulations.
1. Align the battery’s exposed copper contacts with the battery connectors
at the bottom part of the battery compartment.
2. Insert the contacts side of the battery first and then gently push the
battery into place.
3. Replace the back cover.
To remove the battery
1. Make sure your device is turned off.
2. Remove the back cover.
3. The bottom of the phone has a notch. Lift the battery by the notch to
remove it.

17
Charging the Battery
New batteries are shipped partially charged. Before you start using your
device, it is recommended that you install and charge the battery. Some
batteries perform best after several full charge/discharge cycles.
Note: Only the AC adapter and USB sync cable provided with your device
must be used to charge the device.
Connect the USB connector of the AC adapter to the sync connector on
your device, and then plug in the AC adapter to an electrical outlet to start
charging the battery.
As the battery is being charged while the device is on, a charging icon
appears in the title bar of the Home screen. After the battery has been fully
charged, a full battery icon appears on the title bar of the Home screen.
Warning: • Do not remove the battery from the device while you are
charging it using the AC or car adapter.
• As a safety precaution, the battery stops charging before it overheats.
2.3 Install Memory card

18
To have additional storage for your images, videos, music, and files, you
can purchase a memory card and install it into your device.
1. Make sure that your device is turned off, and then remove the back cover.
2. Locate the memory card slot on the upper part of the exposed right panel.
3. Insert the memory card into the slot with its gold contacts facing down
until it clicks into place.
Note: To remove the memory card, press it to eject it from the slot.
2.4 Starting up the device
•Power on/off
To power off your phone, press & hold POWER key. On release, the Phone
options menu opens. Select ‘Power off’ and confirm.
To power on again, press & hold POWER key.
•Silent mode

19
To silence your phone quickly, press & hold the – volume down button to
zero volume. Or on the Home screen, touch and select Settings > Audio
profiles. Select ‘Silent’ check box. You can also long press the power key
and you will get the option to change user profile.
•Screen sleep
After a period of inactivity, your screen will go to sleep (display will turn
black). In sleep, your phone uses less battery power. You can control this
behavior:
•Set screen timeout period
1. On the Home screen, touch and select Settings.
2. Select Display option.
3. Select Sleep, to set the time period of sleep mode
Except when on a phone call, from any screen, press POWER key
(immediately). While not on a call, to lock your control buttons and screen
from accidental touch activation, press POWER key.
You can increase the security of your phone by setting Screen unlock
pattern. Once set, in order to unlock your screen, you’ll have to draw the
correct unlock pattern. You can set your screen unlock pattern as follows:

20
1. On the Home screen, touch and select Settings.
2. Select Security and then scroll down to Screen lock pattern section.
3. Set or change your unlock pattern by selecting Screen lock pattern, as
applicable.
4. Follow the prompts to define your pattern.
Note: You must swipe your finger along the screen to create the pattern, do
not select individual dots. Connect at least four dots in order to create a lock
pattern.
If you want your pattern to be hidden as you draw it, clear ‘Make pattern
visible’ check box.
3.Using Phone Features
3.1 Home