iBeam TE-PSCD User manual

TE-PSCD
Product Manual
The iBEAM TE-PSCD parking sensor kit consists of 4 ultrasonic sensors, a rearview mirror or
external monitor video input/output with audible warning detection all intergraded into the
control box. The system detects the distance between the vehicle and any obstructions with the
use of the ultrasonic sensors mounted in the bumper, external camera (purchased separately) to
external monitor (purchased separately) video display and an audible warning device.
I. Specifications
Rated Voltage: 12V (9-16V)
Rated Current: 20mA~200mA
Detecting Distance: Rear (0’ – 5’) Front (0’- 2.5’)
Ultrasonic Frequency: 40Khz
Working Temperature: -22°~176°F
II. Connection
Insert Wiring Diagram
1) Sensors should be 1.5 to 2.5 feet from the ground, and 4 ¾ to 7 ¾ inches apart from each
other (depending on vehicle application).
2) Install parking sensors by drilling holes out of the back bumper with the supplied 19mm
hole saw bit (make sure when using the angle adapters the thicker side is facing down,
level with the ground and the UP arrow on the back of the sensor is facing up), and install
parking sensors.
3) The rear sensors A/B/C/D should be installed from left to right (looking at the bumper).
This is also how they should be plugged into the control box. (Example A: left, B: mid-
left, C: mid-right, D: right)
4) Connect the RED wire to the +12 volt accessory wire.
5) Connect the BLACK wire to a ground (a metal, non-painted surface).
6) Plug that wiring harness into the parking sensor control box (labeled power)
7) Run the audible warning device cable through the vehicle and mount somewhere in
vehicle’s cabin where the device can be clearly heard with no obstructions (avoid placing
cable where it can get pinched or damaged) and plug cable into the control box (labeled
buzzer).

8) Mount the control box in the rear of the vehicle in a safe place away from rain, heat or
humidity.
*The back up camera and monitor are needed for the video function to work. First plug the video
cable into the control box (labeled video) then run video cable to the video input on monitor and
the other end of the video cable to the back up camera’s output. This will allow for the video to
be displayed on the monitor (in feet) when the parking assist detects an obstruction in the
vehicle’s path when the vehicle is reversing.
NOTE: 1) The parking sensors are not designed to be used in vehicles with metal bumpers.
2) The parking sensors are paintable. There are small rings included that will fit in the
groove on the front of the sensor. When painting, be sure to use these rings so paint does get into
the grooves otherwise the sensors will not work properly.
3) The parking sensor kit is used as a parking aid. Please use your mirrors and look
around to avoid hitting any object.
III. Learning Function
This is a very useful function for vehicles with spare tire, hitch, bike holder, etc. If the vehicle has
a spare tire or hitch on the back, the ordinary parking assist system may detect the tire or hitch
which would result in a continuous false alarm. The learning function on this device can easily
remove false alarms and it will remember the tire or hitch as part of the vehicle, correcting the
alarm.
How to activate the learning function: Make sure there are no objects within 8 feet from the
rear of the vehicle. When the ACC is switched to the ON position, shift the vehicle from PARK
to REVERSE and back continuously 5 times within 10 seconds, after doing this the learning
function is activated and the system will remember the tire/hitch/bike holder’s, location
automatically.
NOTE: When the hitch or tire has been removed, you will have to relearn the parking assist
system so it knows that obstruction has been removed.
1.800.221.0932
www.iBeamUSA.com
460 Walker Street, Holly Hill, FL 32117