Ibera PakRak IB-RA17 User manual

Seat stay
Carrier must be
horizontal
Limited Warranty
Ibera Co. Ltd.
Specifications subject to change without notice. Ibera is a trademark
of Ibera Co. Ltd. All other trademarks are property of their respective
owners. Copyright 2019 Ibera Co. Ltd. Made in Taiwan.
Artwork: 6–2019.
See other Ibera products at www.ibera.info
Ibera warrants this product for normal usage against workmanship, and material
defects to the original purchaser for two year from purchase date. Products
purchased online are not covered by this warranty unless purchased from an
authorised Ibera online store. 1. User assumes all risk of personal injury,
damage to or failure of the product when it is used in jumping, acrobatics or
similar activities. 2. Warranty does not cover any incidental or consequential
damages, such as personal injury or other losses due to accident, neglect,
misuse, abuse, modification, normal wear and tear, improper care and cleaning,
or failure to follow included instructions.
www.ibera.info
USER MANUAL
IB-RA17PakRak CarrierPakRak Carrier
Clamp-on rack for road bikes or other bikes without mounting
holes. Frame-seatpost mounted for light, top loads.
Fits 25–38 mm diameter
seatposts.
Fits 12–25 mm diameter
seat stays.
Front
fig. 6
fig. 9
fig. 13 fig. 14
fig. 12
fig. 10
Seat stay
fig. 11
Seatpost
Light / reflector bracket
Seatpost
Arm clamp
Leg clamp
Square washer
(direction)
Allen bolt
fig. 8
Allen bolt
Allen bolt thread Correct strap length
Incorrect strap length
fig. 7
Strap
Allen bolt
Strap length marker
MOUNT CARRIER ON BIKE
ATTACH CARRIER TO SEAT STAYS
1. Attach legs to bike's seat stays (see fig. 6). Place leg clamps
over a low point on seat stays–position will vary depending
on bike–make sure both left and right clamps are same height.
ATTACH LIGHT / REFLECTOR BRACKET
7. Mount under carrier rear crossbeam. Using 4 mm Allen key
and wrench in unison, mount bracket using medium Allen bolt,
washer and nut–bracket must protrude rearward. Tighten well.
2. Loosen Allen bolt until most of its length is showing
(leave last two or three bolt threads attached) (see fig. 8).
3. Adjust strap length to fit around
seat stay (see fig. 9, 10). Strap end
of bolt should be parallel with strap
length marker (round indent). Wrap
the end of strap (with built-in Allen
bolt) around seat stay and push it
through hole in other side of clamp–
fine tune strap length as necessary.
4. When bolt is pushed through hole, strap must be
snug, and bolt should be long enough to allow square
washer to go behind bolt head. The small, round washer
sits on top of square washer (see fig. 11, 12). Tighten
bolts, but not too firmly as further adjustment may be
necessary.
ATTACH CARRIER TO SEATPOST
5. To attach arm to seatpost, follow the same procedure as for legs above.
TO COMPLETE ASSEMBLY
6. Inspect to make certain:
• Carrier is horizontal
• Carrier has adequate clearance over wheel
• Rear wheel is centred between carrier legs
• Carrier does not touch or obstruct bike chain, freewheel or disk brake
When carrier is mounted correctly and length and angle adjustments
have been made, tighten all bolts securely.