Idex TREBOR PC6 Manual

9/1/2022 – MPC6-D
PC6 OSCILLATOR
Operation / Maintenance
Manual

PC6 OSCILLATOR OPERATION / MAINTENANCE MANUAL CONTENTS
CONTENTS
1UTILITIES / HOOK-UP .................................................................................................3
2OSCILLATOR CYCLE RATE.......................................................................................5
2.1 ADJUSTMENT INSTRUCTIONS .......................................................................5

PC6 OSCILLATOR OPERATION / MAINTENANCE MANUAL PAGE 3
1 UTILITIES / HOOK-UP
Air Inlet: 3/8” Dia. (9mm) supply tube (Use in-line 10µ air filter).
Air Supply: 20-80 psig clean dry air or nitrogen (Refer to pump
operation manual for maximum temperature/pressure
chart).
The Mufflers on the Oscillator control Module can be removed for remote
exhaust and purge connections.
Power: 24VDC @ 200mA
Light Blue – (+24VDC)
White/Blue – (0VDC Common)
Note: Unit must be mounted in clean environment. Chemical fumes can
damage unit.
Figure 1-1

PAGE 4 PC6 OSCILLATOR OPERATION / MAINTENANCE MANUAL
Figure 1-2
! WARNING: Particulate, water and oils in the air supply can damage
the oscillator.

PC6 OSCILLATOR OPERATION / MAINTENANCE MANUAL PAGE 5
2 OSCILLATOR CYCLE RATE
Applications with low flow or highly viscous fluid may require a slower
cycle rate for increased efficiency. A slower cycle rate will also decrease
air consumption.
2.1 ADJUSTMENT INSTRUCTIONS
•Adjust timer dial to adjust cycle rate. To increase, rotate CCW
(counter clockwise) to decrease rotate CW (clockwise).
•Tune cycle rate for least pulsation both on inlet and outlet.
•Cycle rate can set using the following equation:
=
30

C = Cycle rate in Cycles per minute (CPM)
T = Timer setting (seconds)
Timer Setting (seconds)
Cycle Rate (CPM)
1.2
25
1
30
.8
37.5
.6
50
.5
60
.4
75
.3
100
.25
120
.2
150
.15
200
.12
250
.1
300