IO-Link Master with PROFINET Interface PowerLine 8 Ports IP 65 / IP 66 / IP 67
8Set-up 20
8.1 Read device and diagnostic information............................................................................21
9Configuration 22
9.1 LR DEVICE........................................................................................................................23
9.1.1 Remarks.....................................................................................................................................24
9.1.2 IoT: Configure access rights.......................................................................................................25
9.1.3 IoT: Configure the interface to the LR SMARTOBSERVER.......................................................26
9.1.4 Fieldbus: Set PROFINET interface.............................................................................................26
9.1.5 IO-Link ports: Activate data transfer to the LR SMARTOBSERVER ..........................................27
9.1.6 IO-Link ports: Configure operating mode....................................................................................28
9.1.7 IO-Link ports: Set the device validation and data storage ..........................................................29
9.1.8 Firmware: Reset device to factory settings.................................................................................29
9.1.9 Firmware: Reboot the device......................................................................................................30
9.1.10 Configure IO-Link devices..........................................................................................................31
9.2 PROFINET.........................................................................................................................32
9.2.1 Install GSD Files.........................................................................................................................32
9.2.2 Integrate the IO-Link master in the project .................................................................................33
9.2.3 Configure the IO-Link master .....................................................................................................33
9.2.4 Configure IO-Link ports ..............................................................................................................34
9.2.5 Configure IO-Link devices..........................................................................................................35
9.2.6 Read and write cyclic process data............................................................................................36
9.2.7 Read I&M datasets.....................................................................................................................37
9.2.8 Detect diagnostics and alarms ...................................................................................................37
10 Maintenance, repair and disposal 38
10.1 Cleaning process ...............................................................................................................38
10.2 Firmware update................................................................................................................39
10.3 Replace IO-Link device......................................................................................................40
11 Factory settings 41
12 Accessories 42
13 Appendix 43
13.1 Technical data....................................................................................................................44
13.1.1 Application..................................................................................................................................44
13.1.2 Electrical data.............................................................................................................................45
13.1.3 Inputs / outputs...........................................................................................................................46
13.1.4 Inputs..........................................................................................................................................46
13.1.5 Outputs.......................................................................................................................................46
13.1.6 Interfaces....................................................................................................................................46
13.1.7 Operating conditions ..................................................................................................................47
13.1.8 Approvals / tests.........................................................................................................................47
13.1.9 Mechanical data.........................................................................................................................47
13.1.10 Electrical connection ..................................................................................................................48
13.2 PROFINET.........................................................................................................................49
13.2.1 Parameter data...........................................................................................................................49
13.2.2 Cyclic data..................................................................................................................................52
13.2.3 Acyclic data................................................................................................................................54
14 Index 57
