iHome Beauty LUX PRO iCVBT80 User manual

Quick Start Guide
iCVBT80 Vanity Mirror - Quick Start Guide (English)
Size: 153 x 140 mm (folded)
Color: 2C + 2C (PMS Cool Gray 9C & PMS 2705C)
Material: 157gsm Art paper
Dec. 12, 2020
PMS Cool Gray 9C PMS 2705C
LUX PRO
iHome Beauty
iCVBT80
Cover page

!
Charging Mirror
Battery Level Indicators
Charging Devices
• Connect included AC adapter to DC jack on back of mirror
and the other end to a working wall outlet.
outlet
Mirror MUST be connected to power for USB charging from the unit.
• Connect USB cable (not included) to USB port and the other end to your
device to charge.
Red Battery Status LED
Charging = solid red
Fully charged = off
Low Battery = flashing red (mirror is ON, not being charged)
Bluetooth
Button
Red
Battery Status
LED

Light Function
• Press and release the Light Button to select a brightness level:
Hi/Mid/Lo/OFF
Detail Mirror + Cleaning Cloth
Removable Detail Mirror
The back of the 10x magnifying detail mirror has SimpleStick™ micro
suction material for easily attaching and detaching almost anywhere
on non-porous surfaces. If necessary, clean SimpleStick material with
office tape.
Cleaning Cloth
Use the included cleaning cloth to keep the large surface and detail
mirror smudge free.
• Press and hold the Light Button to adjust the lighting mode:
Soft Yellow, Warm White, or Bright White

Bluetooth Audio Function
• Press to lower or raise volume
• Press power button to turn speaker On or Off
• When mirror is On, press and hold the Bluetooth button on back
of mirror for 2 seconds for pairing mode, indicated by the blinking
Voice Button
• Select “iHome LUX PRO” on your device’s Bluetooth menu to connect
To cancel pairing, press the Bluetooth button again
To reset Bluetooth, press and hold Bluetooth button for 10 seconds
• Press to play / pause Bluetooth audio
• Press to answer/end Bluetooth calls
• Press and hold for 2 seconds to decline Bluetooth calls
• Quick double press for next track
• Quick triple press for previous track
• Press and hold for 2 seconds and wait for beep to activate
voice control with Siri®
/ Google Assistant™
Voice control requires an active internet connection on connected Bluetooth device with
iOS 10 and Android 4.1 and later. When activated, the speaker microphone acts as an
extension of the microphone in your smartphone to make/take calls, enable you to ask
Siri®/Google Assistant™ to play music and more.
• RESET mirror: if operation “freezes” or unit otherwise fails to respond properly,
reset the unit by inserting the end of a paper clip or similar into the Reset Port
located on the bottom of the mirror. Bluetooth settings will not be affected.

WARNING/DISPOSAL OF UNIT
Do NOT attempt to change the battery. Doing so will void the warranty and could cause injury and damage to your
device. To dispose of the unit, follow the instructions below:
• Never dispose of used batteries/electronics with ordinary solid wastes, since they may contain toxic substances.
• Always dispose of used batteries/electronics in accordance with the prevailing community regulations.
• Many electronics retailers now recycle batteries and other electronic components at no charge. To find a drop-off
location near you, visit www.call2recycle.com
GENERAL BATTERY PRECAUTIONS
• Never use or charge a battery if it appears to be leaking, discolored, deformed, or in any way abnormal.
• Never disassemble the unit or attempt to remove battery as that could cause leakage of alkaline solution or
other electrolytic substances.
• Avoid charging a rechargeable battery when the temperature is not within 5°C - 35° C (41° - 95° Fahrenheit).
• Never expose a battery to any liquid.
• Never expose a battery to excessive heat such as direct sunlight or fire. Never use a battery pack in an
unventilated vehicle where excessive internal temperatures may be encountered.
• Always keep batteries out of the reach of infants and small children.
IMPORTANT SAFETY INSTRUCTIONS
Please heed all warnings, read and follow all instructions and keep these instructions handy for future reference.
1. Do not use this product near water.
2. Unplug unit and clean only with damp cloth. Stronger cleaning agents, such as Benzene, thinner or similar
materials can damage the surface of the unit.
3. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
4. Heat – This product should be situated away from heat sources such as radiators, heat registers, stoves or other
appliances (including amplifiers) that produce heat.
5. Only use attachments/accessories specified by the manufacturer.
6. Unplug this product during lightning storms or when unused for long periods of time.
7. Damage Requiring Service – This product should be serviced by qualified service personnel when:
- Plug has been damaged.
- Objects have fallen into or liquid has been spilled into the enclosure.
- The unit has been exposed to rain. The unit has been dropped or the enclosure damaged.
- The unit exhibits a marked change in performance or does not operate normally.
8. No naked flame sources, such as lighted candles, should be placed on this product.
9. Attention should be drawn to the environmental aspects of battery disposal.
10. This product is suitable for use in tropical and/or moderate climates.
WARNING:
- To reduce the risk of fire or electric shock, do not expose this product to rain or moisture.
- Do not dispose of batteries in the household trash or fire.
- The mains plug of power adaptor is used as the disconnect device, it shall remain readily operable.
- If the unit is to be unused for an extended period of time, such as a month or longer, charge the unit fully before
storage.
- Sunlight: Never place the mirror in or expose the mirror to direct sunlight. The sun’s rays can reflect to become focused
and cause excessive heat and/or fire. Do not use mirror in direct sunlight as reflected sunlight could injure eyes.

FCC Information
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
• Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
• NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
ISED Information
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
The device comply with ISED RF exposure requirement, users can obtain Canadian information on RF exposure and compliance.
This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
Cet équipement est conforme aux limites d'exposition aux radiations IC CNR-102 établies pour un environnement non contrôlé.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences
et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée
aux deux conditions suivantes :
(1) L’appareil ne doit pas produire de brouillage;
(2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre
le fonctionnement.
L'appareil est conforme aux exigences d'exposition RF ISED, les utilisateurs peuvent obtenir des informations
canadiennes sur l'exposition aux RF et la conformité.
Cet équipement doit être installé et utilisé avec une distance minimale de 20 cm entre le radiateur et votre corps.
Tout changement ou modification non expressément approuvé par la partie responsable de la conformité peut annuler
l'autorité de l'utilisateur à utiliser l'équipement.
CAN ICES-3(B) / NMB-3(B)
iCVBT80QSG-201212-A Printed in China

WARRANTY
For product support information and warranty please visit:
www.ihome.com/support
© 2021 SDI Technologies, Inc. All rights reserved
Questions? Visit www.ihome.com