Ikelite Cannon HV-20 Owner's manual

KKEELLTTEE VVDDEEOO CCAASSEE
SSUUPPPPLLEEMMEENNTTAALL NNSSTTRRUUCCTTOONNSS FFOORR
 CCaannoonn HHVV HHVV HHVV
This supplemental set of instructions describes additional features specific
to your housing model Prior to testing the system in the water please read this
supplement along with the general instruction manual to become familiar with
its features and functions
kelite Video Cases are slightly negative
in salt water for stability This housing has
been water pressure tested at the factory
and has a working depth of m 
HHOOUUSSNNGG CCOONNTTRROOLLSS____________________________________
• Power OnOff  Mode
• StartStop
• Power Zoom
• Photo
• Auto  Manual Focus Lock  Back Light
• Focus Wheel
• Type  Card Switch
• Auto  PMode
• Joy Stick 
• Joy Stick   Function
MMAANN OORRNNGG ________________________________
Orings last several years if properly
maintained Control seals should not need
to be replaced as long as the control shafts
are kept clean and lightly lubricated
Joy
Stick #1
Joy Stick #2/
Function
#6071 Canon H V-20
Base
Bottom Bar
Eyeport
Rec./
S.S.
Type/Card Switch
Snap ShotAuto/P-Mode
Wheel Focus
Power Zoom
Port
Focus Lock/
Back Light
Power
Mirror
Lid Snap
PPRREEPPAARRAATTOONN
PPAACCKKAAGGEEDD WWTTHH
HHOOUUSSNNGG____________________________________________________________________________________________________
• External URPro Color Filter
• nternal Lens Shade
• Silicone Lubricant
CCOOLLOORR FFLLTTEERR__________________________________________________________________________
The installation and usage of the external URPro
color filter is described in the general instruction manual
LLEENNSS SSHHAADDEE______________________________________________________________________________
The internal lens shade helps block light reflection
refraction caused by the interaction of the external color
filter and the port
Carefully thread the lens shade on the front of the
camera lens The lens threads are very fine; DDOO NNOOTTcross thread t should screw on
very easily f it is difficult to turn you are cross threading
Completely thread the lens shade into the camera to avoid any potential
clearance or sealing problems when the camera is installed and the housing is sealed
SSUUPPEERREEYYEE
VVEEWWFFNNDDEERR__________________________________________________________________________________________________________
See exactly what the camera sees underwater using the cameras electronic
viewfinder in conjunction with the kelite SuperEye which is permanently mounted
in the eyeport on the clear back plate The SuperEye extends the viewfinder image
to provide enhanced viewing underwater
LLCCDD MMOONNTTOORR  EEXXTTEERRNNAALL
MMRRRROORR__________________________________________________________________________________
The cameras LCD monitor can be viewed from the rear of the housing using the
external mirror featured on the side of the housing
Open the LCD monitor on the camera rotate ° and then press it back against
the side of the camera The external mirror is hinged so that it can be opened to reflect
the image from the cameras LCD monitor for viewing from the rear of the housing But
this will keep the eye piece turned off and the LCD image will appear opposite left
to right
During transportation please remember to close the mirror by pressing it against
the side of the housing
BBAATTTTEERRYY AANNDD
TTAAPPEE____________________________________________________________________________________________________________________
nstall a fully charged Sony battery on the camera:
Canon NBLH BPL BPL
Other brand batteries may not fit inside the housing
Make sure you have loaded an appropriate digital cassette tape in the camera
External
Color Filter
Internal
Lens Shade

OOPPTTOONNAALL WWDDEE AANNGGLLEE
LLEENNSS____________________________________________________________________________________
The housings port accepts optional mm threaded waterproof WideAngle lenses
such as the kelite  W Epoque DCL and non UWL Type  and Sea&Sea
 These waterproof lenses secure to the outside of the lens port
Should you elect to use the optional kelite  W Epoque non or Sea&Sea
lens carefully thread the waterproof lens on the front of the lens port The lens threads
are very fine; DDOO NNOOTTcross thread t should screw on very easily f it is difficult to
turn you are cross threading
NNTTEERRNNAALL WWDDEEAANNGGLLEE LLEENNSS OOPPTTOONN________________________________________________________________________
Special ports are available for use with the Raynox HD Pro high definition
wideangle lens optional ports sold separately as dome port  or flat lens port
 Raynox HD Pro lens not included Lens nnoottavailable for purchase
through kelite
FFNNAALL
PPRREEPPAARRAATTOONN__________________________________________________________________________________________________________________
Remove the lens cap and cord from the camera Otherwise they may interfere
with the housing seal
The cameras auto focus feature is utilized underwater For best results move
in close to your subject and use the wide angle range to shoot thru as little water as
possible The full zoom range is accessible underwater
Turn the cameras builtin flash OFF Chart shows recommended initial settings
underwater
WWHHTTEE
BBAALLAANNCCEE__________________________________________________________________________________________________________________________
nitially set the white balance to Auto Use the Joy stick controls on the housing
to change white balance
CCoolloorr FFiilltteerr::When using the color filter during the day set camera white balance
to ndoor for  foot depth For  foot depth set white balance to Outdoor
VViiddeeooLLiittee::When using optional Video Lite at N GHT set the camera white balance
to the ndoor position During the DAY use the Outdoor setting for subjects beyond
 feet and the ndoor setting for closer subjects
CCAAMMEERRAASSEETTTTNNGG
Power OnOff  Camera On
Zoom Lever  Wide Angle Setting
Focus  Auto Mode
Exposure  Auto Mode
Program AE  Auto Mode
Shutter Speed   Normal
White Balance  Auto Mode see section
Steady Shot  Off
Builtin Flash  Off
NNSSTTAALLLLAATTOONN
CCAAMMEERRAA
TTRRAAYY________________________________________________________________________________________________________________________________
The camera mounts to the tray which extends from the back plate
of the housing DDOO NNOOTTremove the tray from the back plate
Position the camera against the two
stabilizing pins on the tray and secure with
the camera mounting bolt The camera
should fit easily on the tray and should
be parallel with the sides of the tray
Make certain that the lens shade has been
threaded completely into the camera to avoid
any potential clearance or sealing problems when
the camera is installed and the housing is sealed
NNSSEERRTTNNGG TTHHEE CCAAMMEERRAA________________________________________________________
Check that the oring is clean and properly positioned on the lip of the clear
housing back plate Check that the lens shade is completely threaded into the camera
Once the camera is mounted to the tray as shown above pull the housing
controls out to provide clearance for installing the camera Make sure the lens shade
on the front of the camera fits into the port recess in the front of the housing
DDOO NNOOTTforce this installation; the camera and tray should slide easily into place
so the housings back plate oring is resting against the main housing body n this
position the lid snaps can be positioned over the lid hooks on the housing back plate
and snapped into position to seal the housing
HHOOUUSSNNGG
CCOONNTTRROOLLSS________________________________________________________________________________________________________________
Slide the housing controls back in place making sure they properly align with the
camera functions
Operate each control to see how it works with the camera Some controls such
as startstop will be used frequently Other controls may seldom be utilized Refer to
your camera owners manual for the proper function of each camera control Look
thru the back to be sure that you can see into the viewfinder
When using the housing controls especially the startstop do NOT use excessive force
because you could damage the camera
CCAAUUTTOONN
Remove the lens cap and cord from the camera Otherwise the cord may
interfere with the housing seal
f the housing controls are not properly positioned they could interfere with the housing seal
MMAANNUUAALL FFOOCCUUSS
OOPPEERRAATTOONN______________________________________________________________________________________________
Manual focus may be preferred in low light levels or when the subject possesses
little contrast Set the focus switch to Manual to cancel the auto focus f you want
to manually adjust the focus rotate the manual focus control as desired To reacti
vate the auto focus set the focus switch to Auto
KKEELLTTEE UUNNDDEERRWWAATTEERR SSYYSSTTEEMMSS
 West rd Street • PO Box  • ndianapolis N  USA • 
Email: ikelite@ikelitecom • wwwikelitecom
Camera Mounting Bolt
Camera Tray
O’ring
Back Plate
Internal Lens Shade
Stabilizing
Pins