Ikelite Flex Arm User manual

Flex Arm for Substrobe DS51
Installation Instructions
Flex Arm System
The Flex Arm utilizes "pop-bead" components which provide the
necessary holding power yet effortless repositioning.
On land, the Flex Arm may not support the full weight of the
DS51 Strobe. Over time the pop-beads will loosen slightly and
may not hold the strobe in position on the surface. This is
normal and will not adversely affect the arm holding power while
underwater.
Additional pop-beads are available for purchase in four-piece
lengths (Ikelite Product 9573.44).
Installation Instructions (Illustration on reverse side):
1. Determine the desired length of arm and add or subtract
"pop-bead" components from the Flex Arm as necessary.
2. If not already attached, push the Flex Arm onto the Stem Ball as
shown.
3. Push the DS51 Strobe Mount with pop-bead onto the other end
of the Flex Arm. Firm pressure is necessary to attach the
components.
4. Adjust strobe position as needed while underwater.
5. henever disassembling the unit, leave one pop-bead attached
to both the DS51 Strobe Mount and the Stem Ball.
CAUTION: Do not carry your system by the Flex Arm. The
Flex Arm is not desi ned to be used as a carryin handle.

Illustration
DS51 Substrobe
Flex Arm
Quick Release
Handle
Ball with Extended
Length Stem
Flex Arm Detachment
Points
Ikelite Underwater Systems
50 W 33rd Street
Indianapolis, IN 46208 USA
www.ikelite.com
317-923-4523
Flex Arm for DS51 Attachment_03-0614
ikelite
SUBSTROBE
DS
51
ikelite
© 2014 Ikelite Underwater Systems