impact PT-100 User manual

PT-100
Posing Table
ASSEMBLY INSTRUCTIONS

4.
the mounting bracket with the holes in the tabletop. Fasten all four screws until
secure. Do not overtighten. Tip: Insert all four screws before tightening.
5. Stand the pedestal base on the casters, and lock all casters. Insert the bottom
of the column into the open port of the pedestal base. Press down until the
6. Loosen the locking knob, and adjust the tabletop’s height. Tighten the locking
knob to secure the table’s position. Make sure everything is secure before use.
1.
four screws and mounting bracket from the tabletop with a PH3-size Phillips
screwdriver.
2.
of the riser.
3. Hold the column in one hand, and seat the mounting bracket’s pin holes—
threaded socket, and use the hex key to tighten until secure.
Instructions

One-Year Limited Warranty
This IMPACT product is warranted to the original purchaser to be free from
defects in materials and workmanship under normal consumer use for a period of
one (1) year from the original purchase date or thirty (30) days after replacement,
whichever occurs later. The warranty provider’s responsibility with respect
to this limited warranty shall be limited solely to repair or replacement, at the
provider’s discretion, of any product that fails during normal use of this product in
its intended manner and in its intended environment. Inoperability of the product
or part(s) shall be determined by the warranty provider. If the product has been
discontinued, the warranty provider reserves the right to replace it with a model
of equivalent quality and function.
This warranty does not cover damage or defect caused by misuse, neglect,
accident, alteration, abuse, improper installation or maintenance. EXCEPT
AS PROVIDED HEREIN, THE WARRANTY PROVIDER MAKES NEITHER ANY
EXPRESS WARRANTIES NOR ANY IMPLIED WARRANTIES, INCLUDING
BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY
OR FITNESS FOR A PARTICULAR PURPOSE. This warranty provides you with
to state.
To obtain warranty coverage, contact the Impact Customer Service Department
to obtain a return merchandise authorization (“RMA”) number, and return the
defective product to Impact along with the RMA number and proof of purchase.
Shipment of the defective product is at the purchaser’s own risk and expense.
For more information or to arrange service, visit www.impactstudiolighting.com
or call Customer Service at 212-594-2353.
Product warranty provided by the Gradus Group.
www.gradusgroup.com
IMPACT is a registered trademark of the Gradus Group.
© 2019 Gradus Group LLC. All Rights Reserved. GG5
IMPACT
®
A Gradus GroupBrand