Incy Interiors Sybilla Settee 4003 User manual

1
Sybilla Settee
Australia Item #: 4003
Made in Malaysia for:
Incy Interiors Pty Ltd
2a Piper Street, Bathurst, NSW, 2795
AUSTRALIA
[phone]
www.incyinteriors.com.au
Designed and Distributed in Australia by:
Incy Interiors Pty Ltd
2a Piper Street, Bathurst, NSW, 2795
AUSTRALIA
[phone]
www.incyinteriors.com.au

2
IMPORTANT: READ THESE INSTRUCTIONS
CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE OR
USE YOUR SETTEE.
Please keep these instructions for future reference
Health & Safety:
Do not jump on this Settee
Do not use this Settee if any part is missing, damaged or worn
Do not use this Settee until all fixings are tightly secured
Always use on a level and even surface
Warning: If this settee is on a laminated floor we
recommend you place some protection to avoid
scratching the floor
Care & Maintenance
Periodically check all screws & fixings to ensure they are tightly secured.
It is recommended that 2 people assist whenever you need to change the location of the settee
Keep any sharp object away from the settee
After Sales Customer Service
When you receive your Incy Interiors product, if you need any assistance or if you have any comments
with respect to any aspect of the goods, please contact your local distributor via email.
If you are missing parts you can order parts by emailing us at [email protected] or call
[phone]. Please include the product name, colour, and a brief description of the part you are
missing.
You can also visit our website at www.incyinteriors.com.au for latest product information.
Incy Interiors Pty Ltd
2a Piper Street, Bathurst, NSW, 2795
AUSTRALIA
[phone]
www.incyinteriors.com.au

3
Parts list
Assembly Instructions
Tools Necessary: Screw driver (not included)
NOTE: It may be easier to assemble product with two people.
1. Slot in the wing headboard to headboard as per shown in diagram 3 and 4.
2. Remove the Metal Leg (1) , (2) and Hardware, from the pocket under the settee
3. Place the Metal Leg (1) onto the bottom of the settee at the front, secure using screw 3 x 50mm
(A) as shown in fig.1 below.
4. Repeat the same step for Metal Leg (2) on each of the sides by using screw 3 x 50mm (A) as shown
in fig.2 below.