Indesit BIA series User manual

COOLING
Service Quick Guide
Service Quick Guide
Indesit Company, Service Department
Refrigerators “BIA... and BIAA... and IB... and EBL... and EBLH... and FFUL... and PBAA...”
Models Covered:
Interface:
Artica Entry No Frost Fridge-Freezer Platform
1/2
Function
1 SUPER COOL button (SUPER FRIDGE)
2 SUPER FREEZE button
3 FRIDGE TEMPERATURE adjustment knob
Freezer temperature alarm:
FIRST ALARM THRESHOLD (“A1”):
(consume food or cook then re-freeze)
The SUPER COOL and SUPER FREEZE leds flash
simultaneously and an acoustic alarm sounds.
SECOND ALARM THRESHOLD (“A2”):
(do not consume food)
The SUPER COOL and SUPER FREEZE and
POWER leds flash simultaneously and an acoustic
alarm sounds.
SQG_CL_28_EN
4 SUPER FRIDGE Led
5 POWER Led
6 SUPER FREEZE Led
7 FREEZER TEMPERATURE adjustment knob
3
4
1
3
32
5 6 7
Demo Mode:
These models do not have a DEMO MODE.
Reset Alarms “A1” and “A2”:
To reset the alarm, switch the appliance off and back on again using the freezer control knob.
THE buzzer can be muted by opening and closing the fridge door.

Autotest: activation:
Activation:
1Turn the fridge and freezer knobs to the minimum position (Off).
2Press the Super Freeze button for approximately 6 seconds.
Deactivation:
1By switching the appliance on.
2By unplugging it.
3After 255 seconds of testing (end of autotest).
Artica Entry No Frost Fridge-Freezer Platform
2/2
Autotest Sequence:
Step Duration Action Light Notese
1 5 seconds Pause OFF
2 1 second Probe Check OFF
If the probes have not failed, skip to step 3
If the probes have failed, skip to step 6
3 4 seconds Pause OFF
4 125 seconds FZ Fan ON OFF
Resistenza ON (*)
Damper aperto
5 120 seconds FZ Fan ON OFF Skip to step 8
Heating element ON (*)
Damper closed
6 125 seconds FZ Fan ON Flashing
Heating element ON (*)
Damper closed
7 120 seconds FZ Fan ON Flashing
Heating element ON (*)
Damper closed
8 Autotest ends
(*) Bear in mind that the heating elements are connected in parallel so, in the event only one of them
is interrupted, the Fault will not be displayed
N. B.: The Last Fault is cancelled at the end of the Autotest procedure
When Autotest is activated, any Last Fault or Non Critical Fault is shown on the display for the first
20 seconds, after which the Autotest sequence begins. In the absence of any fault, the sequence as
described in the table begins.