Indesit WIDL126 User manual

Operating Instructions - Washer-Dryer Indesit WIDL126
Control Panel
Detergent dispenser: To add detergent and fabric softener
LEDS: To find out which wash cycle phase is under way. If the delay timer function has been set, the time left until
the programme starts will be indicated.
Drying dial: To set the desired drying cycle
Function buttons: To select the functions available. The button corresponding to the function selected will remain
on.
Temperature dial: To set the temperature or the cold wash cycle
Start/Reset button: To start the programmes or cancel any incorrect settings
On-Off/Door Lock LED: To find out whether the washer-dryer is on and if the appliance door can be opened
On/Off button: To turn the washer-dryer on and off.
Programme dial: To select the wash programmes. The dial stays still during the cycle.
Starting a programme
1. Switch the Washer-dryer on by pressing button All the LEDS will light up for a few seconds and the On-
Off/Door Lock LED will begin to flash.
2. Load your laundry into the washing machine and shut the appliance door.
3. Set the Programme dial to the programme required.
4. Set the wash temperature
5. Set the drying cycle if necessary
6. Add the detergent and any fabric softener

7. Start the programme by pressing the Start/Reset button. To cancel it, keep the Start/Reset button pressed for at
least 2 seconds.
8. When the programme is finished, the On-Off/Door lock LED will flash to indicate that the appliance door can be
opened. Take out your laundry and leave the appliance door ajar to allow the drum to dry thoroughly. Turn the
Washer-dryer off by pressing button
Programme Table
Setting the temperature
Turn the temperature dial to set the wash temperature. The temperature can be lowered or even set to a cold
wash.
Set the drying cycle
Turn the drying dial to set the desire drying type. Two options are available:
A: Based on time, from 40 minutes to 150.

B: Based on the damp level of the dry clothes (Iron: Slightly damp clothes, easy to iron. Hanger: Dry clothes to put
away. Cupboard: Very dry clothes, recommended for towelling and bathrobes).
Table of drying times
A cooling stage is forseen at the end of the drying cycle. If your laundry load to wash and dry is in excess of the
maximum load forseen (see table above) perform the wash cycle, and when the programme is complete, divide up
the garments and put part of them back in the drum. Now follow the instructions provided for a dry only cycle.
Repeat this procedure for the remainder of the load.
Dry only
Turn the Programme dial to one of the drying settings (7-8) depending on the type of fabric, then select the desired
drying type using the drying dial.
Functions
To enable a function:
1. Press the button corresponding to the desired function according to the table below.
2. The function is enabled when the corresponding button is illuminated.
The rapid flashing of the button indicates that the corresponding function cannot be selected for the programme set.