indusigns Fyre S User manual

Firewood rack Fyre S
Installation manual

3
Use a soft surface during installation to avoid
damage
01| Pre-assembly
Supplies
- Pencil
- Level
- Allen wrench
- Impact drill
- Masonry drill Ø8mm
- Socket wrench 13
6st Lag screw
6st Plug
8st Bolt
4st Carriage bolt
4st Coupling nut
4st Sealing cap large
8st Sealing cap small
Contents of the package

4 5
03| Mounting brackets02| Installation
8x

6 7
05| Mounting on the wall04| Sealing caps
1. Position the rewood rack against the wall on the
desired place.
2. Use a spirit level to ensure that the rewood rack
hangs straight.
3. Mark the 6 positions (holes in the brackets) on the wall.
Use a pencil or marker for this.
4. Remove the rewood rack from the wall.
5. Drill the holes with a Ø8mm masonry drill, 40mm deep
using an impact drill.
6. Place the 6 supplied plugs in the drilled holes.
7. Reposition the rewood rack in the correct position.
8. Fix the rewood rack with the 6 supplied
l ag bolts using a 13mm socket wrench.
Tighten the bolts properly!
6x
Cover the holes in the rewood rack with the supplied
sealing caps 8x
4x

Thank you for your purchase!
Have fun with your rewood rack | Fyre