indusigns Hairpin Table Frame Original User manual

Hairpin Table Frame | Original
Installation manual

Supplies
- Pencil
- Long ruler
- Tape measure or measuring
tape
- Wood drill Ø3mm
- Phillips screwdriver
Met koppelelement:
4st Black Allen screw
4st Black nut
8st Black metal washer
16-28st Felt pads
16-28st Rubber washer
16-28st Metal washer
16-28st Wood screw
Contents
Of
With coupling element Without coupling element
2x 2x

3
Use a soft surface during installation to avoid
damage
01| Determine position
Place the tabletop upside down on a soft surface (e.g. a rug) to prevent scratches.
Draw a center line along the length and width of the sheet to determine the position of the frames.
Place the frames with the mounting plate on the table top and position them as desired. Make sure
that they are symmetrically aligned with respect to the blade and each other.
Coupling element: When determining the position, pay attention to the alignment of the coupling
element with respect to the frames.

4
Add some felt pads to the top of the hairpin frame.
02| Add felt pads
Felt pads

5
03| Determine position with coupling element
Coupling element: When determining the position, pay attention to the alignment of the coupling
element with respect to the frames.
The next two steps deal with the coupling element.
Don’t have a link? then skip steps 3 and 4 and proceed to step 5.

6
03| Fix coupling element
Coupling element: When the frames are positioned correctly, secure this unit with the coupling
element. Use the supplied black bolts, nuts and washers for this.
Attach the coupling element to each frame with two bolts: one like this
close to the center and one as far from the center as possible.
Tighten the bolts and nuts well so that they are tight.

7
03| Drill holes in the tabletop
Mark the holes on the table top and remove the hairpin frames from the table top.
Pre-drill the holes at the marked positions with a Ø3mm wood drill bit. Remove the sawdust from
the holes.

8
04| Fix the tabletop
Replace the frames with the mounting plate on the table top and align them with the holes.
When the frames are positioned correctly, they can be attached with the supplied fasteners.
Tighten the screws well, but never overtighten them. If they are stuck it is enough. If you hear wood
creaking while screwing, remove the screw and drill the hole a little further.

9
05| Turn the table
Flip the table. Do this with several people to prevent any damage.
The installation is now complete and the table is ready for use.

Thank you for your purchase!
Have fun with your Hairpin Table Frame | Original