indusigns Rupin User manual

Hairpin Table Frame | Rupin
Installation manual

Supplies
- Pencil
- Long ruler
- Tape measure or measuring
tape
- Wood drill Ø3mm
- Phillips screwdriver
Contents
12st Felt pads
12st Rubber washer
12st Metal washer
12st Wood screw

3
Use a soft surface during installation to avoid
damage
01| Determine position
Place the tabletop upside down on a soft surface (e.g. a rug) to prevent scratches.
Draw a center line and the center point on the sheet. Then position the hairpin table frame on it
and measure again whether it is exactly in the middle.

4
02| Drill holes in the tabletop
Mark the holes on the table top and remove the hairpin frame from the table top.
Pre-drill the holes at the marked positions with a Ø3mm wood drill bit. Remove the sawdust from
the holes.
Add some felt pads to the top of the hairpin frame and to the legs.

5
03| Fix table top
Place the frame with the mounting plate on the table top again and align it with the holes.
When the frame is positioned correctly, it can be xed with the supplied fasteners.
Tighten the screws well, but never overtighten them. If they are stuck it is enough. If you hear wood
creaking while screwing, remove the screw and drill the hole a little further.

6
03| Turn table
Flip the table. Do this with several people to prevent any damage.
The installation is now complete and the table is ready for use.

Thank you for your purchase!
Have fun with your Hairpin Table Frame | Rupin