Note: Place recessed holes
for Interlude Foot Pads
face up.
Assembly viewed
from the left
Note: When assembled, the slot
for wire access on the tower top
should face the left side.
5/16 x 18 FLAT
HEAD SCREWS (2)
Front
Left side
Right side
Back
Interlude Mounting
Plate
Included – This Infinity speaker stand is designed to be used with the
Intermezzo 2.6 or Interlude IL10 speaker.Below are the pieces that are
included for this speaker stand.
Intermezzo 2.6 –When used with Intermezzo 2.6
speakers,the rounded edge of the Mounting Plate should face
the outer side of the stand assembly;the same side as the
decorative side panel on the front of each Intermezzo speaker.
STEP 2A
ScrewTower to Base with (2) 5/16 x 18 Round Head
Screws.Note that it is important which direction the slot in the
TowerTop faces depending on the application desired.See
Steps 2A and 2B for possible applications.
Outer
side Outer
side
Assemblies viewed
from the rear
Assembly
for RIGHT
side use
Assembly
for LEFT
side use
Note: The slot for cord and
wire access is facing the rear
The Intermezzo Mounting Plate
is simply turned over for left or
right application
5/16 x 18
FLAT HEAD
SCREWS (2)
5/16 x 18
FLAT HEAD
SCREWS (2)
Interlude IL10 –When used with Interlude IL10
speakers,the assembly process is the same,regardless of LEFT
or RIGHT placement.
STEP 2B
STEP 1
