InFocus SP7205 Use and care manual

Replacing the Lamp
Turn off the projector
Unplug the power cord. Allow the projector to cool for 30 minutes.
Loosen the two screws on
the lamp door.
Tighten the lamp screw.
Install the new lamp.
Replace the lamp door
and tighten the two screws. Plug in the power cord and
press the Power button. To reset the lamp counter,
hold the two Brightness
buttons down for 10 seconds.
Lift the lamp door up.
Loosen the lamp screw. Lift the old lamp out.
!
9
*009-0718-00*
12
12
11
11
10
10