INNOSILICON T2T-24T BTC User manual

T2T-24T BTC
USER MANUAL
INNOSILICON CONFIDENTIAL

Table of Contents
1. OVERVIEW 1
2. ASSEMBLE THE MINER 2
2.1 Check the miner before power on 2
2.2 Connect the PSU 3
3. OPERATE THE MINER 4
3.1 Enter the miner console 4
3.2 Set up the pool 4
3.3 Check the hashrate of the miner 5
3.4 Network configuration 5
3.5 Other pages 6
3.5.1 Overview 6
3.5.2 Upgrade 6
3.5.3 Modify the password 7
3.5.4 Reboot 7
3.5.5 Factory reset 7
INNOSILICON CONFIDENTIAL
INNOSILICON T2T-24T BTC
INNOSILICON CONFIDENTIAL

1
1. OVERVIEW
INNOSILICON CONFIDENTIAL
T2T-24T BTC
Part Number T2T-24T
Algorithm Sha256
Size (L×W×H) 408mm(L)*135mm(W)*232mm(H)
Net Weight 8.82KG (with PSU)
Operating Temperature 0-40 ℃
Network Connection Ethernet
INNOSILICON CONFIDENTIAL
Mode Performance Factory Balance Efficient
Hashrate 24TH±5% 22TH±5% 20TH±5% 18TH±5%
Power dissipation 1980+10% 1760W+10% 1530W+10% 1240W+10%
Typical Hashrate and Power Dissipation of the Four Mode:（You can set the mode follw the manual 3.5.1)

2
2. ASSEMBLE THE MINER
2.1 CHECK THE MINER BEFORE POWER ON
·Check the warranty sticker is well or not, especially the hashboards PSU port side. If the warranty sticker
is damaged when you received the miner, please contact our After-sales.
·Before you power on the miner, shake the miner softly, if you can hear the sound of metal banging on
metal, please contact our After-sales.
·Check if the fan work well, if you find the fans broken please contact our After-sales.
·The cable connection should be same as the follow picture.
INNOSILICON CONFIDENTIAL
T2T-24T BTC
INNOSILICON CONFIDENTIAL
Note:
There is a led on each hashboard, which can show the work status of the hashbaord.
When the miner start to work, the led
Solid---workig well
Blink---the hashboard overheat, please check the fans of the miner and the room temp
Off---the hashboard don’t work, please try to reboot the miner or change the data cable. You can contact
our after-sales team if the problem is still exist.

3
2.2 CONNECT THE PSU
Note: The sequence of the PSU cable should be same with the follow picture（Change the sequence of the
PSU cable will void the warranty.
IP SET button:
Press it 1—4 seconds, it will (1) show the IP of the miner in the “Set IP” tool; (2) change the miner to Static
IP mode and modify the IP to the IP range you set in the “Set IP” tool
Press it 4—15 seconds, the miner will become to DHCP and the settings of the miner should be restore to
default.
Press it more than 20 seconds to switch the Dynamic (Static) IP to Static (Dynamic)
RESET button: Your miner will restart if you press it..
INNOSILICON CONFIDENTIAL
T2T-24T BTC
INNOSILICON CONFIDENTIAL
Connect the miner and the router by the Ethernet cable, then the miner can start to run after power on
the miner.