Innova 3.0 User manual

1 di 4
INSTRUCTIONS FOR INNOVA
3.0 ATOMIZER
1. Characteristics

2 di 4
2. Unpacking
After verifying the integrity of the package, open the shipping carton and remove the polystyrene
protection; then remove the atomizer. Access to the unit is only permitted to specialized personnel.
3. Electrical connections
Before proceeding with the hydraulic connections, check that the atomizer is not plugged in.
4. Water supply connection
The atomizer has a superior hole on the top cover for pipes with outside diameter of 13mm.
Insert the condensate pipe in the upper hole and check that it enters into the atomizer for at least 30 mm.
If the 3.0 atomizer is combined with Innova 2.0 air conditioner it’s necessary to install the included tap as
shown at chapter Errore. L'origine riferimento non è stata trovata. for changing season.
5. Water mist connections
The atomizer 3.0 already has a 80mm diameter fitting for ejecting atomized water . This connection can
be extended with normal pipe ( 80mm diameter).
Ensure that these extensions have a slope of at least 3 ° to let in the atomizer any condensate water in the
tube and that the output connection is free from any obstacles for a distance of 50 cm.
Avoid excessive stress on the atomizer output connection.
6. Installation template
When installing atomizer near the wall for the expulsion of water on the outside, drill a hole of 82 mm
diameter on the wall as picture below.

3 di 4
7. Electrical connections
8. Functioning
3.0 atomized water by wave propagation generated by piezoelectric cells 10 in the direction of the water
surface. On the free surface of the water, generate droplets of small dimensions, which are removed by
forced ventilation. 3.0 has level floating that keep constant the amount of water above the piezoelectric
cells to maintain a high performance for the condensate.
The atomizer goes on standby automatically if the water level falls below the minimum level and
automatically activates the heating cable (optional) when the water temperature falls below 3 ° C.
3.0 has a CP contact to interface with the 2.0 air conditioner when there is any failure or malfunctions.
CP contact to be
connected to 2.0
air conditioner
230 V AC
power supply

4 di 4
9. Changing function mode and warnings
In Innova combinations of 2.0 air conditioner + 3.0 atomizer is very important to do the following steps to
avoid buzzer alarms.
In the package is shipped a tap to be grafted into the rubber tube to drain condensate in place of the T-
junction (see fig. below).
During the cooling operation (summer season) the tap must be CLOSED, while in the winter season is
OPEN. In this way the condensate produced during the summer season remains in the collection pan of
2.0 and is evaporated on next start.
10. Troubleshooting
The device is equipped with some light and sound signals that indicate the status and any malfunctions:
 GREEN LED: atomizer power supply on
 ORANGE LED: atomizer running
 RED LED: atomizer in stand-by and electrical heater on
 BLINCKING RED-GREEN LED + BUZZER: alarm
The reasons for alarms may be the following:
 maximum level sensor activated
 level sensors wrong (for example the maximum level sensor is busy when normal level sensor is
off)
 bad indication of condensate temperature
Insertion tap position