INNOVAPLAS 9080 User manual

x 2
AA battery
X4
Battery not
included
REQUIRED FOR SKU # 9080
1) Assemble the step according to enclosed instructions. Keep
step dry during installation.
2) Remove the Innovaplas round cap from the step by
compressing the 2 clips at the back.
3) Insert the lighting fixture from the outside of the step.
4) Pass mounting ring through front of hole and fasten using the 2 screws provided.
5) Insert light fixture by aligning the ring and turning 1/4 turn towards left.
6) Apply locking screw. Plug it in.
IMPORTANT: Use supplied tie-wraps to attach electric cord to a post as
shown. Do not submerge the battery pack, the product could
be dammaged.
LIGHT FIXTURE # 9080
REV. 2013/01/16
3 4
2
65
A
WARNING
TABLE OF CONTENTS
A) Light installation on the step.
B) Deck installation.
C) Step combo Installation
E) Winter storage & used
battery disposal.
LIGHT INSTALLATION ON THE STEP
TOOLS REQUIRED (Not Included)
COMPATIBLE WITH ANY INNOVAPLAS STEP
CONTAINING THE INNOVAPLAS CREST ROUNDEL
The pool Step Company
LIMITED WARRANTY
MANUFACTURER
WARRANTY
30 days on manufacturing defects.
Replacement only.
Risk of drowning by entangle-
ment; secure the power cord
with tie wrap supplied as per
instructions.

DECK INSTALLATION*
STEP COMBO INSTALLATION*
TIE
WRAP
REV. 2013/01/16
The pool Step Company
Remove the step and light fixture assembly from the pool and store in a
dry and unexposed storage facility.
Do not dispose of used batteries in the regular trash bin! Recycle used
batteries at approved local facilities.
WINTER STORAGE & USED
BATTERY DISPOSAL
B
D
C
CAUTION
The lighting fixture may be damaged if subjected to freezing weather.
Remove the entire step assembly from the pool and allow all water to
drain from the step and dry before storing.
Store in a dry location unexposed to winter conditions.
Do not throw used battery in trash bin that may contain hazardous
materials.
370, boul Lajeunesse O.
Saint-Jérôme, QC
J7Y4E5
WWW.INNOVAPLAS.COM
1) Install the battery as per above instructions.
Peel the adhesive backing.
2) Apply on platform edge.
3) Secure the electrical cord to the tubular post with
the two tie wraps provided.
+
+
+
+
+
+
+
+
*Suggested instal-
lation, other
battery pack
location possible.
1) Unfasten the four screws and remove the battery cover.
Install the 4 AA battery with the correct polarity as described.
2) Make sure that the surface is free of dust and free of grease
before you apply the adhesive tape. Peel the adhesive backing
from the back of the box.
3) Apply on the deck bracquet or other suitable locations.
4) Secure the electrical cord to the tubular post with the tie wraps
provided.
TIE
WRAP
*Suggested instal-
lation, other
battery pack
location possible.
Do not submerge the battery pack, the product could be dammaged.
Contact your Innovaplas dealer for more
informations on the product.