Innovative UltraRack URPS User manual

Innovative UltraRack
Paint Stand • Assembly Instructions
Install Total Lock Caster Wheels.
Secure to Support Tubes P/N 220-001.
Slide Inside Frame Post
(P/N 220-004) into Frame post.
Install Index Plate lower bolt
(finger-tight only).
Install Trunnion Bracket
(P/N 220-005) using 3⁄8x 2cap
screw, through upper
Index Plate hole.
Attach Locking Hex Nut to the 2 Cap
Screw from step 5. Do not overtighten.
Trunnion Bracket should rotate freely.
Now firmly tighten lower Index Plate bolt.
Put left and right Extension arms
into storage position. For use with
pickup tailgates only.
Insert Support Arms.
See arrows - hooks point away from
center of UltraRack.
Insert T-Frame Tubes.
Upper T-Frame P/N 220-007.
Lower T-Frame P/N 220-006.
U.S. PATENT 7,448.606
1
5 6
7 8 9
™
Attach Support Tubes to Frame Base
tube (P/N 220-002); tighten firmly.
2
Attach Frame Post (P/N 220-003)
to Frame Base Tube; tighten firmly.
Insert T-handle.
3
4
Insert T-Handle
lower T-Frame
Upper T-Frame
Top Hooks UP
Bottom Hooks DOWN
Insert T-Handle
Height Adjustment

SuperStand
I
Innovative UltraRack
Assembly Drawing
™
Innovative Door-Fender Stand™
P/N: I-DF
If you have any comments, questions or concerns about our products or are missing a part, please
contact us toll-free at 1-866-438-4884 or 651-415-0733 or visit www.innovativetools.com/contacts
Upper Support 230-005 Qty: 2
Drop Arm 230-006 Qty: 2
Right Support Arm 230-010 Qty: 2
Rubber Sleeve 230-028 Qty: 8
Pin with Clip 230-013 Qty: 1
Base Cross Support 230-000 Qty: 1
Tee Handle 430-022 Qty: 8
Base Leg 230-001 Qty: 2
Total Lock Caster wheel 4TLCW Qty: 4
Right Clamp Arm 230-012 Qty: 1
Quick Release Pin 230-007 Qty: 4
Base Upright 220-003 Qty: 1
Plastic Knob 250-026 Qty: 6
Rubber Sleeve 250-027 Qty: 4
Left Support Arm 230-009 Qty: 2
Connecting Sleeve 230-008 Qty: 2
Left Clamp Arm 230-011 Qty: 1
CENTER HOOK P/N 220-040 QTY (1)
PIN WITH CLIP P/N 230-013 QTY (2)