innove Glass Chiller User manual

User’s Manual

Packing List
1.glass chiller ×1
2.Instruction book ×1
3.Seal ring ×2
WARNING:This product works with liquid CO2 only.Never connect any
other compressed gas cylinders with high pressure.A liquid CO2 cylinder
with siphon tube is preferred to deliver liquid CO2.If a standard gas CO2
cylinder is used , the cylinder must be placed upside down to deliver liquid
CO2 .Install this product in a well ventilated area;otherwise a high level of
CO2 may Accumulate.

Prepare before use
Step1:we need a tube to the bottom in our CO2 tank ,so we turn
on our chiller machine we can gain perfect chiller performance!
Step2:Install the gas hood
of our machine
Step3:Powering the led light
The led light requires 2AA batteries.
To add the batteries,simply remove
the black cover located at the
top of the machine.

Installation
Step1:
Install the machine on your desk or bar counter,
the thickness of you bar counter must be 15mm to 80mm
Clockwise the pole

Step2:
Connect the CO2 Value
Keep the value closing
The steel wire cover the valve for safety

Put the Rubber Seal Rings in the nut and then Use our finger to
screw the nut until we can’t screw
Use the wrench to reinforce the nut and valve

Step2:
Turn on the tank and press the chiller machine,then it begin to
Work
Change the CO2 Cylinder
When the frosting time exceeds 10 seconds,this is an indication
that it is time to change the cylinder,please follow these
instructions carefully.
1. Close the shut-off value of the cylinder
2. Press the switch of the glass chiller until all pressure is
Released
3. Loosen the fitting connecting the unit to the cylinder
4. Finally,connect the unit to the new VO2 cylinder following the
instruction out lined on the previous page

More details, you can visit our website or contact us.