Inseego AI-12 User manual

AI-12 Dashcam Installation Guide
Product Variations: AI12 LTE 4G
Version: 03.07.2022
Overview
The AI12 dashcam solution consists of a single bodied camera providing both road and driver view.
In addition, it provides the driver with Realtime AI driver behaviour events such as Distracted Driver, Cell Phone Use and
Driver Behaviour. These events are displayed on the in-cab screen.
It is essential that all devices are onboarded correctly, and it is essential that our support team are contact after every
installation.
Connection of Power:
1. Locate a permanent power source in the vehicle. (12 or 24v)
Note: It is suggested using either the fuse panel or ignition barrel.
2. Connect the provided power supply cable to the power source. Red > Permanent Power, Black > Ground.
Note: It is essential that a 2amp fuse is used on the permanent feed.
3. Route the power cable up the side pilar and along the roof lining towards the rear vision mirror.
Note: Ensure the cable does not obstruct any moving parts and is securely fixed.
4. Connect the power cable to the dashcam.
Pre-Mounting Steps:
1. Ensure the vehicle is parked on a level surface.
2. Clean the window with an alcohol wipe and dried.
Mounting the Dashcam:
1. Slide the dashcam into the mounting bracket provided.
2. Loosen the screws on the right-hand side of the camera this will allow the body to twist and the appropriate
angle to be set.
3. Press the dashcams touch screen and enter the following pin code: 2112
4. Press the live view icon, use the arrow keys to toggle between the road view and in-cab view.

5. Hold the camera up to the window and establish a suitable mounting location ensuring the following
requirements are met:
a) Ensure the dashcam is not mounted on any window tint, shade or antenna commonly found
surrounding the rear vision mirror. This can affect mounting and GPS lock.
b) Clear view of the driver upper body.
Note: It is essential you can see the entire upper body (Seatbelt waste strap to just above the
head)
c) Clear view of the road
d) The dashcam does not obstruct the driver’s field of vision.
e) The distance to the dashcam is further than your arm.
1. Once the correct angle is found tighten the screws again.
2. Perform one final check of the camera angles.
3. Remove the 3M adhesive tape on the camera bracket and attach the camera to the window.
4. Call customer Customer Support for final viewing angle sign-off and testing.
Installing the Tamper Proof Case and Sticker:
1. Remove screws from tamper proof case.
2. Apply tamper proof sticker as shown in image below:
Note: The objective of this sticker is to prevent the driver from adjusting the viewing angle.
3. Position the tamper proof case around the right-hand side of the dashcam.
4. Tighten the security screws.
Note: Please ensure the tamperproof screwdriver is provided to the installation contact. It must not be left in the
vehicle or provided to the driver.
Support Contact
You can now contact customer support on Australia 1300 304 033 | New Zealand 0800 899 000 to commission
the camera. You will have to give them the IMEI, registration and Field Work Order.
It is important to leave the vehicle ignition ON during the commissioning. The commissioning team will inform you
of any potential faults and make you change the angle of the cameras if they are not correctly adjusted.
The Inseego Customer Support team is available between 8.30am - 5pm Mon through Fri.