V3 ENGLISH 21-0051
CLEANING AND MAINTENANCE
To clean your ice maker, follow the instructions in steps 3-5 in SETTING UP YOUR ICE
MAKER.
• Clean the ice maker at least once a week or every three days if your water quality
is poor.
CAUTION: Do not use bleach or vinegar to clean the internal components.
TIPS FOR SAVING ENERGY
• Locate your ice maker in the coolest area of the room, away from heat
producing appliances or heating ducts.
• Make sure that your ice maker is suciently ventilated, with adequate air
circulation behind it.
TROUBLESHOOTING
The ADD WATER indicator is on.
• Turn o your ice maker, open the cover, then remove the ice basket. Add water
up to the MAX line. Replace the basket, then close the cover. Turn on your ice
maker.
The ICE FULL indicator is on.
• Remove ice from the ice basket.
Ice cubes stick together.
• The ice cycle is too long for the room temperature. Stop your ice maker, and
restart it when the ice blocks melt. Select the small size ice cube selection.
• The water temperature may be too cold. Change the water
in the inner tank. The best water temperature is between 45°F ~ 90°F (7°C ~
32°C).
The ice making cycle is normal, but no ice is made.
• The room temperature or water temperature may be too high. The room
temperature should be 50°F ~ 105°F
(10°C ~ 40°C). The water temperature should be
45°F ~ 90°F (7°C ~ 32°C).
• The refrigerant liquid may have leaked. Contact a qualied service technician
for repair.
• The pipe in the cooling system may be blocked. Contact a qualied service
technician for repair.
The ice maker will not stop.
• Direct sunlight or sunlight reection can cause the sensor to malfunction.
Move your ice maker.
My ice maker is noisy.
• Your ice maker makes noise during the freezing cycle and when it is dumping
ice. This is normal.
SPECIFICATIONS
Dimensions (H×W×D): 8.7 × 12.3 × 12.6 in. (22.1 × 31.2 × 32.0 cm)
Net weight: 15.7 lbs. (7.1 kg)
Protection type: 1
Power: 115 V/60 Hz
Wattage: 120 W (25°C), 140 W (40°C)
Ice making current: 1.7 A
Ice harvest current: 2.0 A
Refrigerant: R2600 a/21 g
Design pressure:
High side: 290 psig
Low side: 88 psig
Enclosure: Silver, red, mint, or white
Ice cube weight:
Small: .25 oz. (7 g)
Large: .32 oz. (9 g)
Reservoir capacity: 2.11 qt. (2.0 l)
ONEYEAR LIMITED WARRANTY
Visit www.insigniaproducts.com for details.
CONTACT INSIGNIA:
For customer service, call 1-877-467-4289 (U.S. and Canada) or
01-800-926-3000 (Mexico)
www.insigniaproducts.com
INSIGNIA is a trademark of Best Buy and its aliated companies
Distributed by Best Buy Purchasing, LLC
7601 Penn Ave South, Richeld, MN 55423 U.S.A.
©2021 Best Buy. All rights reserved.
SETTING UP YOUR ICE MAKER
1Place your ice maker on a level surface in a location where your ice maker is
protected from direct sunlight and other sources of heat (such as a stove,
furnace, or radiator).
2Make sure that there is at least 4 inches (10 cm) of space between the back
and sides of your ice maker and the surrounding walls.
3Clean the interior with diluted detergent, warm water, and a soft cloth, then
rinse with clear water.
4Take out the ice basket and clean it.
5Unplug the water drain cap to remove all water. Replace the water drain plug
before lling with water.
6Before using your ice maker for the rst time, run two to three cycles of ice
and dispose of them to help remove any plastic odor or residue from the
manufacturing and shipping process.
USING YOUR ICE MAKER FOR THE FIRST TIME
WARNINGS:
• Your ice maker must be grounded. Do not defeat the safety purpose of the
grounding-type plug. A grounding-type plug has two blades and a third grounding
prong. The third prong is provided for your safety. If the provided plug does not t into
your outlet, consult an electrician for replacement of the obsolete outlet.
• Before plugging in your ice maker, wait one hour for the refrigerant uid to settle.
1Make sure that the water drain plug is in place and secure.
2Open the cover, remove the ice basket, then pour drinking water into the
reservoir. Make sure that the water level is below the MAX line.
WARNING: Fill with drinking water only
3Replace the ice basket, then close the cover.
4 Plug the power cord into a power outlet.
5Press the ON/OFF button. The power indicator lights.
6Press the SELECT button to select the ice cube size. If the room temperature is
lower than 60°F (16°C), we recommend that you select the small cube size to
keep ice from sticking together.
Notes:
• When the ice basket is full, your ice maker automatically stops making ice and the ICE
FULL indicator lights.
• After ice is made and goes into the ice basket, the ice begins to melt. To save the ice,
remove it from the basket and freeze it. Otherwise, the ice melts, the water goes back
into the reservoir, and your ice maker recycles the water to make ice again.
• The ice making cycle lasts 6 to 13 minutes, depending on the selected ice cube size and
the ambient temperature. If the room is extremely hot, the cycle may take longer.
• While your ice maker is on, check the water level periodically. If the water level is too
low, your ice maker stops automatically and the ADD WATER indicator light will
illuminate. Turn o your ice maker, then ll the reservoir to the level mark. Wait at least
three minutes for the refrigerant liquid inside the compressor to settle, then turn on
your ice maker.
• Change the water in the water reservoir every 24 hours to ensure that the water is fresh
and the ice tastes good.
• If your ice maker is not in use, drain all water left in the tank.
MAX line
NS-IMP26SL0 _RD2_MT2_WH2_21-0051_QSG_V3_EN.ai 2 1/12/2021 4:40:24 PMNS-IMP26SL0 _RD2_MT2_WH2_21-0051_QSG_V3_EN.ai 2 1/12/2021 4:40:24 PM
