inspired LED 5014 User manual

Inspired LED 1733 E. McKellips Rd. Suite #111 Tempe, AZ 85281 [phone] www.inspiredled.com
Key Function
1On/Off
2Change Pre-Programmed Setting
3White Light / Color Light
4Increase Brightness/Speed
5Decrease Brightness/Speed
Mode Description Key 4/5 Function
1Auto Color Changing 8 grades of Brightness
2Three Color Jump
3Seven Color Jump
4Three Color Gradual
5Seven Color Gradual
6Blink Red
7Blink Blue
8Blink Purple
9Blink Green
10 Blink Yellow
11 Blink Cyan
12 Blink White
13 Blink Red/Blue Alternately
14 Blink Green/Blue Alternately
15 Blink Red/Green Alternately
Pre-Programmed Color Changing Mode Chart for 'Key 2'
8 grades of Speed
8 grades of Brightness
8 grades of Speed
Connect Power
Plug 12V Inspired LED Power Supply into the power connector.
Connect LEDs
Plug all RGB flex into the four-pin RGB output.
On/Off
Press 'Key 1' to turn the RGB LEDs on or off in any state.
Solid Color
Press 'Key 3' once to activate white light mode. Press 'Key 3' again to activate
color light mode, and select a desired color by using the touch wheel. Change
brightness in either mode by pressing 'Key 4' or 'Key 5'.
Pre-Programmed
Color Changing
Press 'Key 2' to activate light changing mode, cycle through 15 pre-programmed
modes by pressing 'Key 2' again.
Remote Match
Press 'Key 4' once within three seconds of connecting power to the controller to
match the remote to the controller. The connected lights will blink 3 times if
successfully matched. One remote may be matched to multiple controllers.
Remote Clear
Press 'Key 4' five times within three seconds of connecting power to the controller
to clear a remote from a controller. The connected lights will blink 6 times if
successfully cleared and the remote will no longer influence the controller.
Remote Sensitivity
Please don’t touch or press the touch wheel within 3 seconds of loading the
batteries to protect the sensitivity of the remote. If the touch wheel loses
sensitivity, remove and reinstall the batteries.
How to Use the RGB Controller
5014 RF Wireless RGB Controller from Inspired LED
The RF Wireless RGB Controller from Inspired LED is a sleek,
convenient solution to controlling RGB LED Lighting. Choose
from 15 different pre-programmed color changing modes, or
simply select a solid color from the color wheel, by using the
remote from up to 65 feet away from the controller. Turn the
entire system on and off with the remote - when the system is
turned back on, the previous setting will be resumed.
+12VDC
G
R
B
Look for + or Arrow on connector products
Connect to +12VDC
Cut Flex to length and solder on interface connector
12 VDC Power Supply
RGB
Remote
Controller Cable
5009
RGB Flex Strip
Four Conductor Cable
5005 through 5008

Mouser Electronics
Authorized Distributor
Click to View Pricing, Inventory, Delivery & Lifecycle Information:
Inspired LED:
5014