Installation
Avoid mounting your InstaHANGER product in high foot traffic areas
NOTE: PROPER INSTALLATION IS ESSENTIAL. Please Read all instructions before proceeding.
1. Establish a mounting location within the guidelines as described on this Installation Template.
2. Using a pencil NOT a pen, draw a LIGHT vertical reference line through the center of the selected
mounting location.
3. Tape the template to the mounting surface such that the reference line passes through the exact center of
the template at an established height.
4. Pierce template with a screw to mark top & bottom screw locations. Install screw anchors (if necessary)
as outlined in the Easy Install Guide.
5. Partially install screws into wall surface leaving half of screw shaft exposed.
6. Set InstaHanger on the wall by aligning the mounting slots of the unit with the mounting screws & allow
the unit to slip down to resting position.
7. Remove the end of the hanging rod from base section for full access to upper mounting screw head(s).
8. Pull cover up, slide the rod up & out of the entry slot of the molded sliding channel.
9. Tighten screws snugly. Do not over tighten.
10. Reinsert end of hanging rod into entry slot of base section. You're DONE!
Easy Install Guide
Installation in Masonry block, Brick, Concrete, & Solid Plaster—Drill 1/4" diameter holes 11/2" deep
minimum, with masonry drll bit. Install 1 plastic plug in each mounting hole by tapping in until flush with
surface of wall before installing with two 1 3/4" wood screws. Tools Needed — measuring tape, pencil, drill,
1/4" masonry bit,  Philips screw driver. Carpenter's level is optional.
Installation in Wood or Drywall over Solid Wall Stud — Pre-drill 7/16" pilot holes at marked locations
before installing with two 13/4" wood screws. Tools Needed — measuring tape, pencil, drill, 7/64" drill bit,
& # 2 Philips screrelriver. Carpenter's level is optional. Installation in Drywall (Hollow Wall) Use two 13/4"
wood screws & follow hollow wall plastic anchor instructions below. Plastic hollow wall anchors are for 1/2"
thick drywall ONLY. Tools Needed — Measuring tape, pencil, drill, 5/16" drill bit, # 2 Philips screwdriver.
Carpenter's level is optional.
1. The standard rod height is 66" (168 cm) measured from the floor. This height allows hanging of full
length garments.
2. Model AH12 The top screw for the base section should be exactly 9" (23 cm) above the desired rod
height. So, for the standard rod height, the top screw should be 75" (190 cm) from the floor.
3. The right & left positions of the base section should be at least 12" (30cm) from any obstructions. If
mounting near a door, open the door to determine the space it takes when fully opened.
Installation Teclutique
