modway EEI-2671 User manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 2
EEI–2671 CHAIR
Hardware:
Component:
A Bolt M6x16mm x 12
1
Chair Body x1 3 Back Leg x2
D Allen Wrench M4 x 1
1
2 2
3
Spring Washer M6 x 12
Flat Washer M6 x 12
B
C
3
2 Front Leg x2
Thank you for purchasing the MODWAY Chair！
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2.Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components and
hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe and
environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all fitting out of reach of children.

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 2
EEI–2671 CHAIR
STEP 1:
STEP 2:
Ax12 Bx12 Cx12 Dx1 Hardware & Tool required
Please put Chair Body (1) upside down on a carpeted or padded area.
Positon 1 piece of Back Leg (3) to the bottom of Chair Body (1).
Insert 3 pieces of Bolt (A) with 3 pieces of Spring Washer (B) and 3 pieces of Flat Washer (C) into the holes on
bottom of Chair Body (1) through the holes on Back Legs (3) as shown.
Repeat the same steps for the remaining Back Leg (3) and Front Legs (2).
Use Allen Wrench (D) to tighten Bolts (A) clockwise until secure.
D
Assembly is complete. Your chair is ready to be use now!
Carefully turn over the assembled chair.
A
B
C C B A
A A
B
C
B
C
1
3 3
2
2
Direction label towards front